Not applicable
Jul 10, 2020
10:15 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 10, 2020
10:15 AM
Hi,
What is a good, simple, inexpensive debug / flash program solution? There seem to be a lot of choices out there. I will be using it on a TC375 with a custom board.
Ideally, it would work within the Aurix Development Studio.
Thank you,
Charlie
What is a good, simple, inexpensive debug / flash program solution? There seem to be a lot of choices out there. I will be using it on a TC375 with a custom board.
Ideally, it would work within the Aurix Development Studio.
Thank you,
Charlie
- Tags:
- IFX
1 Reply
Not applicable
Jul 14, 2020
08:09 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 14, 2020
08:09 AM
I seem to ask the wrong questions. Sorry. I like the way the debugger / flash programmer works on the dev board. I see that it has a FTDI chip which translates USB to UART and JTAG? (I think it is JTAG but it could be DAP) The FTDI data sheet explains this pretty well.
It also has an EEPROM hooked up to it. Is this necessary for use as a debugger or an extra feature of the dev board? If it is necessary, is the image available? This is a lot to grasp and I need some help.
Thanks,
Charlie
It also has an EEPROM hooked up to it. Is this necessary for use as a debugger or an extra feature of the dev board? If it is necessary, is the image available? This is a lot to grasp and I need some help.
Thanks,
Charlie