Jul 08, 2020
01:38 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 08, 2020
01:38 PM
Hi there,
I am wondering if it is possible to use the ethercat out port as a regular TCP/IP port. I see that the BCM5241XA1 is not listed as a supported PHY in the app, but the app does also allow for user defined phys. Has anyone done this before?
Regards
Dave
I am wondering if it is possible to use the ethercat out port as a regular TCP/IP port. I see that the BCM5241XA1 is not listed as a supported PHY in the app, but the app does also allow for user defined phys. Has anyone done this before?
Regards
Dave
- Tags:
- IFX
3 Replies
Jul 10, 2020
06:15 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 10, 2020
06:15 AM
Hi,
It is not possible since the pins used for the EtherCAT ports are not connected and/or the functionality does not correspond to the ones of the Ethernet MAC module.
Check the Table 11 Port I/O Functions in the XMC4300 data sheet.
Regards,
Jesus
It is not possible since the pins used for the EtherCAT ports are not connected and/or the functionality does not correspond to the ones of the Ethernet MAC module.
Check the Table 11 Port I/O Functions in the XMC4300 data sheet.
Regards,
Jesus
Oct 05, 2020
06:26 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 05, 2020
06:26 AM
jferreira wrote:
Hi,
It is not possible since the pins used for the EtherCAT ports are not connected and/or the functionality does not correspond to the ones of the Ethernet MAC module.
Check the Table 11 Port I/O Functions in the XMC4300 data sheet.
Regards,
Jesus
Is it possible to use the ethercat ports as a regular TCP/IP port on XMC4800 development kit.
Oct 13, 2020
03:03 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 13, 2020
03:03 AM
Hi,
It is not possible to use the ethercat ports as ethernet mac ports.
It is possible to use EoE (Ethernet over EtherCAT).
The support of EoE needs to be implemented in the master and slave stacks.
Check:
https://github.com/OpenEtherCATsociety/SOES
https://github.com/OpenEtherCATsociety/SOEM
Regards,
Jesus
It is not possible to use the ethercat ports as ethernet mac ports.
It is possible to use EoE (Ethernet over EtherCAT).
The support of EoE needs to be implemented in the master and slave stacks.
Check:
https://github.com/OpenEtherCATsociety/SOES
https://github.com/OpenEtherCATsociety/SOEM
Regards,
Jesus