+ Reply to Thread
Results 1 to 3 of 3

Thread: Use from SWD and UART interface on the same port P0.14 and P0.15 at the same time

  1. #1
    Beginner Beginner Matrix is on a distinguished road
    Join Date
    Sep 2017
    Posts
    6
    Points
    62.5

    Use from SWD and UART interface on the same port P0.14 and P0.15 at the same time

    Hi guys,

    After reading a lot of papers and webpages I'm a little confused. Question: Can I use the swd interface and the UART interface at the same time with BMI = SWD0? The goal of this would be to communicate over the UART while the firmware is been debug.

    uC = XMC1302

    Thank you in advance

    Pablo

  2. #2
    Beginner Beginner Howard73 is on a distinguished road
    Join Date
    Feb 2019
    Posts
    2
    Points
    60
    I am not sure this is possible but I have the exact same question so tagging along here in case somebody replies.

  3. #3

    Infineon Employee
    Infineon Employee
    jferreira will become famous soon enough
    Join Date
    Oct 2012
    Posts
    844
    Hi,

    It is not possible. Once you decide to go with BMI=SWD0, the pins will be used exclusively for the debug interface.
    An alternative would be to use the BMI=SPD0/SPD1 and use the remaining pin to implement UART in half duplex mode.

    Regards,
    Jesus
    The views expressed here are my personal opinions, have not been reviewed or authorized by Infineon and do not necessarily represent the views of Infineon.

+ Reply to Thread
Disclaimer

All content and materials on this site are provided “as is“. Infineon makes no warranties or representations with regard to this content and these materials of any kind, whether express or implied, including without limitation, warranties or representations of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, whether express or implied, is granted by Infineon. Use of the information on this site may require a license from a third party, or a license from Infineon.


Infineon accepts no liability for the content and materials on this site being accurate, complete or up- to-date or for the contents of external links. Infineon distances itself expressly from the contents of the linked pages, over the structure of which Infineon has no control.


Content on this site may contain or be subject to specific guidelines or limitations on use. All postings and use of the content on this site are subject to the Usage Terms of the site; third parties using this content agree to abide by any limitations or guidelines and to comply with the Usage Terms of this site. Infineon reserves the right to make corrections, deletions, modifications, enhancements, improvements and other changes to the content and materials, its products, programs and services at any time or to move or discontinue any content, products, programs, or services without notice.