Nov 07, 2013
11:05 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 07, 2013
11:05 AM
Hi,
Is there any trick to enter BSL mode without pulling down TMS at startup? Maybe enabling some sort of pull down on TMS at runtime then restarting the micro?
Or viceversa, is it possible to enter BSL mode and then leave it after some time?
I would like to be able to use only the serial line to flash the micro without using dip switches ... .
Many thanks
Frank
Is there any trick to enter BSL mode without pulling down TMS at startup? Maybe enabling some sort of pull down on TMS at runtime then restarting the micro?
Or viceversa, is it possible to enter BSL mode and then leave it after some time?
I would like to be able to use only the serial line to flash the micro without using dip switches ... .
Many thanks
Frank
- Tags:
- IFX
1 Reply
Nov 10, 2013
06:55 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 10, 2013
06:55 PM
frankmag wrote:
Hi,
Is there any trick to enter BSL mode without pulling down TMS at startup? Maybe enabling some sort of pull down on TMS at runtime then restarting the micro?
Or viceversa, is it possible to enter BSL mode and then leave it after some time?
I would like to be able to use only the serial line to flash the micro without using dip switches ... .
Many thanks
Frank
Sorry to say that this is not possible. The TCK and TMS levels need to be set according to the tables for respective Boot modes. However you might want to review the possibilities of BMI for your application.