Hi ,
We are using your 16 bit micro controller in our product as below.
SAK- C167CR-LM -GA-T
SAK- C167CR-LM -GA
SAK- C167CR-LM -GA-T-6
SAK- C167CR-LM -HA+

We are aware that this Micro controller is obsolete. However we have done LTB for it. In this we got mixture of parts as below
SAK-C167CR-LM Errata Data Sheet - Step Codes GA - March 2003.pdf
From documents for errata, we understand that these GA , GA-T etc are design steps.
Pl. elaborate what are differences in these design steps suffix parts? GA , GA-T , GA-T-6 etc.
Is there any document which clarifies this? Pl. share.
Does all these design step suffix parts are functionally same and pin to pin compatible ? with same footprint ?
Can we use these parts as replacement to each other ?
Pl. revert at urgent.
Thanks,
Amod
(Amod Mujumdar)