Apr 22, 2020
06:07 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 22, 2020
06:07 AM
Hello
Please suggest solution for automatically programming / XMC1200 and XMC1300 .
I need hardware suggestion (the programmer needed) and software suggestion (command line interface software for integration in custom own GUI)
Thank you
Please suggest solution for automatically programming / XMC1200 and XMC1300 .
I need hardware suggestion (the programmer needed) and software suggestion (command line interface software for integration in custom own GUI)
Thank you
Labels
- Tags:
- IFX
3 Replies
Apr 23, 2020
08:22 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 23, 2020
08:22 AM
Hi,
I'm new to XMC ,but from what i read most XMC's support ASC BSL.It allows to load programs in SRAM.It should be possible then that the loaded program to flash the uC.If this is feasible then you would only need a UART communication IC like an FTDI one,FT2232 comes to mind now.
I'm new to XMC ,but from what i read most XMC's support ASC BSL.It allows to load programs in SRAM.It should be possible then that the loaded program to flash the uC.If this is feasible then you would only need a UART communication IC like an FTDI one,FT2232 comes to mind now.
Apr 30, 2020
07:22 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 30, 2020
07:22 AM
that it is not a solution . I need to buy a programmer and use the software that comes with it . Is that so hard?
Apr 30, 2020
08:24 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 30, 2020
08:24 AM
Other than checking out Segger's portofolio of tools I have 0 ideea.
Look up XMCLink also.Is Jlink based ,but only for XMC.
Look up XMCLink also.Is Jlink based ,but only for XMC.