Apr 09, 2020
07:23 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 09, 2020
07:23 PM
I have done some investigations on it, but I can't find anything useful to implement the UART function with my Automation V2 Board.
I found that the TCK from the debug connector can do this, but it seems this wire is not connected to the MCU when I read the schematics.
Anyone can give some tips to use the UART trace function, I am facing a very hard block issue at present. Thanks!
I found that the TCK from the debug connector can do this, but it seems this wire is not connected to the MCU when I read the schematics.
Anyone can give some tips to use the UART trace function, I am facing a very hard block issue at present. Thanks!
0 Replies