Feb 04, 2020
06:21 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 04, 2020
06:21 AM
Hello,
I´m trying to receive an extern interrupt.
I used Dave APPs(- EventDedector ; EventGenerator; NVIC; DIGITAL IO)
I never get into the service routine... I used example : XMC4500_RelaxKit_ERU_ISR
Its not working on XMC4300 Board with button 2 but i changed it to a other Pin.
Im using a jumper wire (3,3V - Pin0.6) but without getting in InterruptService Routine....
Someone have experience with that case ?????
I´m trying to receive an extern interrupt.
I used Dave APPs(- EventDedector ; EventGenerator; NVIC; DIGITAL IO)
I never get into the service routine... I used example : XMC4500_RelaxKit_ERU_ISR
Its not working on XMC4300 Board with button 2 but i changed it to a other Pin.
Im using a jumper wire (3,3V - Pin0.6) but without getting in InterruptService Routine....
Someone have experience with that case ?????
1 Reply
Feb 05, 2020
05:58 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 05, 2020
05:58 AM
Hi,
Have a look at the Usage section of the EVENT_GENERATOR APP documentation.
You should be using, Generate service request = Independent of pattern detection
1. In this mode, each occurring trigger event leads to a service request.
2.The Pattern Match Output Signal can be used independently from the Trigger Output Signal for gating purposes of other peripherals.
3. Gating Output Signal is always enabled and Gated Trigger Output Signal becomes activated with each activation of Trigger Output Signal
Alternatively you can use the PIN_INTERRUPT APP.
Regards,
Jesus
Have a look at the Usage section of the EVENT_GENERATOR APP documentation.
You should be using, Generate service request = Independent of pattern detection
1. In this mode, each occurring trigger event leads to a service request.
2.The Pattern Match Output Signal can be used independently from the Trigger Output Signal for gating purposes of other peripherals.
3. Gating Output Signal is always enabled and Gated Trigger Output Signal becomes activated with each activation of Trigger Output Signal
Alternatively you can use the PIN_INTERRUPT APP.
Regards,
Jesus