Jan 31, 2020
10:48 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 31, 2020
10:48 AM
Hello Support,
In a Pristine SAK-TC387TP device from Infineon without any Flash Image content being present within the device, is it guaranteed ALM21[0]=0 [ Same as PMS_AG21_STDBY[0] =0] assuming all external Power Supply to the device is perfectly matching the Datasheet Specification.
Assume all Power Supply are being supplied externally instead of any of the internal voltage regulators.
Best Regards,
In a Pristine SAK-TC387TP device from Infineon without any Flash Image content being present within the device, is it guaranteed ALM21[0]=0 [ Same as PMS_AG21_STDBY[0] =0] assuming all external Power Supply to the device is perfectly matching the Datasheet Specification.
Assume all Power Supply are being supplied externally instead of any of the internal voltage regulators.
Best Regards,
- Tags:
- IFX
3 Replies
Feb 07, 2020
10:12 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 07, 2020
10:12 AM
Please check EVRADCSTAT.UVC: that corresponds to the mechanism that sets ALM21[0] (hoping that link gets fixed in the next iteration of documentation). If that's set, then look for high frequency noise on 1V25 that may be causing the alarm. Use an active probe if possible.
Feb 08, 2020
03:34 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 08, 2020
03:34 AM
Hello Support,
For BGA-292 SAK-TC397 Aurix device, Ball G17 is PORST_N signal.
Will activating [pulling down] PORST_N signal clear this PMS_AG21_STDBY Register contents to zero?
During Cold Power On, will this PMS_AG21_STDBY register bits get set/fault before PORST_N signal is deactivated [pulled high] if any external supply are beyond spec due to noise/glitch?
Best Regards
For BGA-292 SAK-TC397 Aurix device, Ball G17 is PORST_N signal.
Will activating [pulling down] PORST_N signal clear this PMS_AG21_STDBY Register contents to zero?
During Cold Power On, will this PMS_AG21_STDBY register bits get set/fault before PORST_N signal is deactivated [pulled high] if any external supply are beyond spec due to noise/glitch?
Best Regards
Feb 10, 2020
07:27 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 10, 2020
07:27 AM
Per Table 523 on page 1289 of AURIXTC3XX_um_part1_v1.4.pdf: an external power-on reset resets the SMU (clearing all alarms).
Your application should clear supply related alarms at startup, based on this section from the user manual:
Your application should clear supply related alarms at startup, based on this section from the user manual:
11.2.2.5.2 Secondary over- and under-voltage monitors and alarm generation
After start-up, it may happen that supply over- or under-voltage alarms may already have been triggered depending on residual start-up voltages or supply dynamics.