Jan 01, 2020
05:37 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 01, 2020
05:37 AM
Dear all,
I'm trying to use the TLE9879 Eval Kit to drive a 24V BLDC motor.
However, every time I increased the voltage of DC power to be more than 5V, over-current protection is generated, which means the DC power cuts off itself.
The board should be able to handle 24V. What could the problem be?
Thanks.
I'm trying to use the TLE9879 Eval Kit to drive a 24V BLDC motor.
However, every time I increased the voltage of DC power to be more than 5V, over-current protection is generated, which means the DC power cuts off itself.
The board should be able to handle 24V. What could the problem be?
Thanks.
Labels
1 Reply
Jan 12, 2020
10:35 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 12, 2020
10:35 PM
Hello Rayking,
Which code are you using with the TLE9879 Evalkit?
Is the the overcurrent detected by the power supply or by the TLE9879?
Best,
Fiz
Which code are you using with the TLE9879 Evalkit?
Is the the overcurrent detected by the power supply or by the TLE9879?
Best,
Fiz