Dec 23, 2019
11:06 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 23, 2019
11:06 PM
Hi, I am using D2G board (doppler mode) to extract raw data to matlab for processing.
Using the function provided, I can get the 256 points IQ signal just like the time domain plot in infineon toolbox software.
But I would like to know what is the period/time duration that the 256 samples represent, since the x-axis of the plot is samples instead of time.
Where can I find it? Thanks.
Using the function provided, I can get the 256 points IQ signal just like the time domain plot in infineon toolbox software.
But I would like to know what is the period/time duration that the 256 samples represent, since the x-axis of the plot is samples instead of time.
Where can I find it? Thanks.
Solved! Go to Solution.
1 Solution
Jan 27, 2020
03:25 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 27, 2020
03:25 PM
If you know your sampling rate, then you can calculate the amount of time elapsed per sample (total_sampling_time = num_samples / sampling_rate). The interface should provide a way to retrieve and set your sampling rate.
1 Reply
Jan 27, 2020
03:25 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 27, 2020
03:25 PM
If you know your sampling rate, then you can calculate the amount of time elapsed per sample (total_sampling_time = num_samples / sampling_rate). The interface should provide a way to retrieve and set your sampling rate.