Dec 18, 2019
03:19 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 18, 2019
03:19 AM
Hi,
I am trying to automate a process that include loading a new program into de TriCore board, run it for a a while and them load a new program.
But after loading a new program TriCore needs an reset, which we want to automate.
Is there a way to send a reset signal via CLI using any of the Aurix Tools, in order to automate the process?.
Or any other recommendation to achieve that objective?.
Thanks in Advance
euw15
I am trying to automate a process that include loading a new program into de TriCore board, run it for a a while and them load a new program.
But after loading a new program TriCore needs an reset, which we want to automate.
Is there a way to send a reset signal via CLI using any of the Aurix Tools, in order to automate the process?.
Or any other recommendation to achieve that objective?.
Thanks in Advance
euw15
- Tags:
- IFX
1 Reply
Jan 21, 2020
07:29 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 21, 2020
07:29 AM
Generally the TriCore supports a software reset via an SFR or via the debugger. The specifics to this depends on the specific TriCore device you are using and your connection.