Nov 13, 2019
12:16 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 13, 2019
12:16 AM
Hi,
I use the BEMF demo code to drive my own PCB board. In open loop , it runs good. But when it switch to close loop , the motor stoped.
I got the error message as below, when the motor entered the EMO_MOTOR_STATE_START5, it always stoped.
How to solve this problem?
Best!
I use the BEMF demo code to drive my own PCB board. In open loop , it runs good. But when it switch to close loop , the motor stoped.
I got the error message as below, when the motor entered the EMO_MOTOR_STATE_START5, it always stoped.
How to solve this problem?
Best!
- Tags:
- IFX
2 Replies
Nov 20, 2019
10:47 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 20, 2019
10:47 PM
Hi LiangXiao,
I am working on this topic and will come back to you as soon as possible.
Best,
Fiz
I am working on this topic and will come back to you as soon as possible.
Best,
Fiz
Nov 26, 2019
11:39 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 26, 2019
11:39 PM
Hi LiangXiao,
which motor are you using for the BEMF commutaion?
Best,
Fiz
which motor are you using for the BEMF commutaion?
Best,
Fiz