Nov 12, 2019
10:12 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 12, 2019
10:12 PM
I have the evaluation kit of DPS310 (EVAL SHNBV01) which comes with the BLE module. It works with the Infenion mobile app very well.
My question is how to use this kit with another MCU?
There are 2 external connector lines at both sides of the board which facilitates to solder it to another board. But I cannot find any document which explains the pin map.
I need to find the Vcc, Gnd, SCL and SDA pins in order to connect the sensor to a microcontroller.
Any help regarding this is highly appreciated.
My question is how to use this kit with another MCU?
There are 2 external connector lines at both sides of the board which facilitates to solder it to another board. But I cannot find any document which explains the pin map.
I need to find the Vcc, Gnd, SCL and SDA pins in order to connect the sensor to a microcontroller.
Any help regarding this is highly appreciated.
Labels
0 Replies