Issue while programming IRMCK099 OTP

Announcements

From sunburn to sun earn – we’ve got the power! Watch our #poweringgreen videos now.

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
User12027
Level 1
Level 1
First question asked First reply posted
Hello all,

We started using the IRMCK099 about 3 years ago, and we always were able to program the OTP correctly, both Fw and parameters.

Now we had to come back on the project to modify the .bin and the parameters files a little bit, but we encounter following issue.

After programming the fw to OTP, the "program completed failed" message always appears.
After programming the param file to OTP, the same message appears (usually at this point, the "how many free parameter slots are available" should appear).

The funny thing is that, despite of these messages, both board a motor are running correctly, so OTP seems to be programmed.

Did anyone encounter this "issue", and eventually find a way to solve it?
Even if it's working, we are obviously afraid of "error" o "failed" messages.



FIY: the only thing we changed, is that we installed the new data-pack since it was more up to date.
In the new downloaded data-pack, tinyWizard is working with .tw2 files, instead of .tw from the older version.
Also, the .txt parameter file contains different information compared to the files generated from the old TinyWizard version.
Therefore, we modified "by hand" the older parameter files with the new values, since the modifications that we want to perform in the project are small.


Thanks in advance for a feedback.

Cheers, Matteo
0 Likes
2 Replies
User12027
Level 1
Level 1
First question asked First reply posted
Update:

we were able to solve the issue by updating the MCETOOLV2 firmware to v1.1 (in order to do this without spending too much time, we had to buy a second MCETOOLV2, which is being used as updating interface).
Previous firmware version of our MCETOOLV2 was v0.2. After updating it, the messages finally say everything is OK. Also the parameter to OTP programming outputs finally tell the "available free slots".

Best regards, Matteo
0 Likes
snget2
Moderator
Moderator
Moderator
5 sign-ins First like received 25 replies posted

Thank you, for using this iMOTION1.0 (IRMCK099), we are not support this product anymore. It's obsolete.

we are recommend you to start with your new design with iMOTION2.0(IMC101T, or IMD111T)

0 Likes