Oct 24, 2019
05:41 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 24, 2019
05:41 PM
Hi. I am using a XMC400 controller. The software is DAVE 4. I try to check the variables and registers on debugging. I found no matter what variable I typed in, DAVE cannot find it. It shows "Error: Target not available". What could be the reason of this error?
I just create a variable called "kkk". It keeps increasing. The PWM will read it and change the duty cycle. It works actually. I can see the duty cycle on oscilloscope. However, I can't read "kkk" on Expression window.
I just create a variable called "kkk". It keeps increasing. The PWM will read it and change the duty cycle. It works actually. I can see the duty cycle on oscilloscope. However, I can't read "kkk" on Expression window.
0 Replies