Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob

Welcome to the Infineon Developer Community

  • 109716 Discussions

  • 114849 Members

  • 68854 Solutions

filter icon

Featured Discussions

Sort by:
Filter by forum
odissey1
Code Examples
This is an example of the DDS sine signal generator running on PSoC4200M CY8CKIT-044 Pioneer Board. Like the previous example,  this project also uses... Show More
deslibris
MOSFET (Si/SiC)
Are you ready to share your story with the world? Look no further than Deslibris & Amazon Kindle Direct Publishing to streamline your eBook publishing... Show More
karthikpchetty
ModusToolbox™
Hello,   I see the build warning as below in the latest MTB 3.2 version. Is this an issue that can be fixed by Infineon or else it is upto the ARM? -I... Show More
totot
AIROC™ Wi-Fi and Wi-Fi Bluetooth Combos
What is the SDIO type used in the CYW55572   and CYW55573 and what is the maximum data rate for each of these? Show More
MesihK
Wi-Fi Bluetooth for Linux
Hello, We are using 1YN - CYW43439 with CYW4343A2_001.003.016.0031.0000.1YN.hcd firmware. We are experiencing the following error when we connect mult... Show More
Konstantinos
MOTIX™ MCU
Hello,I am using the BLDC shield TLE9879 with Arduino through Arduino IDE, to simply drive a BLDC motor with the HALL mode. Is it possible to have acc... Show More
下头
TRAVEO™ T2G

如何开启DMA,用DMA读取ADC,SPI,USAT等

navin
Power Management ICs
We have a custom board in which we are using PMIC consisting of IRPS5401MTRBF chip, to get knowledge about this we have ordered EVAL_PS5401-25A (EVK B... Show More
shivamsharma
AIROC™ Bluetooth
I have a CYBT-343026-01 module and I want to connect a speaker and want to play the sound using CYBT-343026-01 module with the help of Audio_headset a... Show More
Translation_Bot
Smart Power Switches
zhege 这个BTS7004-1EPP,后面负载没有直接接电机,而是通过电机驱动芯片接电机的话,这个RGND是不是可以去掉,直接接地就行了?,谢谢!This BTS7004-1EPP, the back load is not directly connected to the motor, bu... Show More