Featured Discussions
Ti gave a link to Cypress telling to download the driver, the link is as follows
https://community.cypress.com/docs/DOC-12366 but the link says it's archived and can't be downloaded
The normal FX 3 driver won't work again, can you share this driver with me?
smartconx_target@Q!w2e3r4t5y6u7i8o9p0||/t5/USB-EZ-PD-Type-C/%E5%AF%BB%E6%89%BE%E9%80%82%E9%85%8DTi%E7%9A%84%E9%A9%B1%E5%8A%A8/td-p/741911
Show LessHi, I am using the ICE2HS01G in a high voltage application.
Sometimes, the IC does not go into burst mode and keeps switching continuously even with the LOAD pin pulled down to ~0V by the feedback control based on the TL431 IC.
Is this a reported issue with noise, perhaps on the Vsense line?
Thanks,
SS1
Show LessHello,
I am looking for the Firmware project (Eclipse Project) for the OV7251 Image Sensor. Even a simple implementation that offers the following functionalities will be sufficient:
- UVC-compliant output
- 640x480 pixel resolution
- Raw video
Does anyone have a project that can be shared?
Thanks in advance,
Mo
Show LessHi,
I am programming the IR35204 Chip.
Loop1 Vout is successfully shown our setting.
But Loop2 Vout has a low level and looks like a noise.
is there a any solution about Loop2 Operation successfully?
Please Let me know
Thank you for your help
Show LessHi,
I want to translate the following article to Japanese. Please confirm to my work.
KBA "Where to check when there are errors changing Build Configuration from Release to Debug"
URL: https://community.infineon.com/t5/Knowledge-Base-Articles/Where-to-check-when-there-are-errors-changing-Build-Configuration-from-Release/ta-p/741600
Best Regards,
Hayashi.K
Hi,
I want to translate the following article to Japanese. Please confirm to my work.
KBA "Short circuit safe operation area of IM241 CIPOS™ micro IPM series"
URL: https://community.infineon.com/t5/Knowledge-Base-Articles/Short-circuit-safe-operation-area-of-IM241-CIPOS-micro-IPM-series/ta-p/740439
Best Regards,
Hayashi.K
Hi,
I want to translate the following article to Japanese. Please confirm to my work.
KBA "Set and modify the stack size for PMG1 code examples in ModusToolbox™"
URL: https://community.infineon.com/t5/Knowledge-Base-Articles/Set-and-modify-the-stack-size-for-PMG1-code-examples-in-ModusToolbox/ta-p/740409
Best Regards,
Hayashi.K
Hi,
I want to translate the following article to Japanese. Please confirm to my work.
KBA "Speed sensor's type of hysteresis"
URL: https://community.infineon.com/t5/Knowledge-Base-Articles/Speed-sensor-s-type-of-hysteresis/ta-p/740399
Best Regards,
Hayashi.K
We use an Infineon FP 420 L 90 B magneto-resitive sensor to sense position in a precision tilt mechanism, but Infineon no longer makes this part. Does anyone know of a replacement part made by Infineon or another vendor that could take the place of this device?
Show LessHi, I am using Aurix TC375 Lite Kit development board and tried the freeRtos example code.
But after compilation, once the code is put in the debugger mode then the tsim issue comes as below snapshot --
Please get me a solution for this issue asap.
Thanks.
Show Less