XMC™ Forum Discussions
How to select a project as active debug when DAVE opens multiple projects?
smartconx_target@Q!w2e3r4t5y6u7i8o9p0||/t5/XMC/active-debug/td-p/723640
Show LessI'm utilizing Dave apps to set up XMC1400 as an SPI Master device. I've enabled the frame end mode with a frame size of 16. My Question is, can I alter the frame size within the main function after generating the application code?
Show LessDear team i am trying to create a CAN tx inbuild programe But showing to fail .I am adding the pic for your reference Kit is XMC 1404 boot 001 .
Show LessHi all,
I used DAVE APP ENCODEF_POSIF to read the incremental position sensor. For this I read absolute_poscount and convert it to linear position.
my question is how to clear this counter like Index marker but in software ?
Thanks.
Show LessI'm utilizing Dave apps to set up the XMC1400 as an SPI_Master with half-duplex communication. However, I'm encountering an issue where the microcontroller maintains the data pin at a high state when the master isn't transmitting, resulting in collisions when attempting to receive data from the slave, as depicted in the figure below. How can I resolve this problem?
Show Less
Actually i am trying to pass the address of the slave but i didn't get inbuild function for that things .Can you guide me which function is use full for configuring the slave as transmitter .
I used this function.
Hello,
In our company we use many cards with an Infineon processor, XMC4500.
When we communicate with them in TCP communication
we encounter the same problem that repeats itself on all cards.
General description of the system:
Each system has several cards with an XMC4500 processor,
Once a second we send a command (via TCP) to all cards and wait for a reply.
The system is supposed to be ON 24/7, what happens today is that after a few days (2, 3 days on average) the communication with the card stops and only a reset to the card restores it to activity.
When the communication stops - what happens is that you can't send requests to the specific port, but when you send a ping request it works.
The processor continues to run, the TCP communication stops.
The ETH_LWIP app is set up the same as in your examples.
Do you have any idea what causes this problem and how to solve it?
this is very important to us.
Thank you
Yehudit
Show LessHello,
what's the relationship between "time interval" in APP configuration and "TIMER_SetTimeInterval" in function?
You can see I have set the "Time interval[usec]" to 1200, and then I use function "TIMER_SetTimeInterval" set to 1.
Then what is the real time interval I have set? After How long time will the "time interval event" be triggered?
Thanks!
Show Less