+ Post New Thread
Page 1 of 8 1 2 3 4 5 ... LastLast
Threads 1 to 20 of 142

Forum: 32-bit Embedded Power ICs based on ARM Cortex-M

Infineon Embedded Power ICs are specifically designed to enable mechatronic motor control solutions for a range of motor control applications, where a small package form factor and a minimum number of external components are essential. Our System-on-Chip solutions offer an unmatched level of integration of all functions required to sense, control and actuate a motor.

Sub-Forums Last Post

  1. Frequently Asked Questions for the 32-bit Embedded Power ICs

    Forum Actions:

    Forum Statistics:

    • Threads: 3
    • Posts: 74
  1. Sticky Thread Sticky: Infineon Embedded Power IC Information

    Dear Community, We have established direct product links for our Infineon Embedded Power IC family. Visit us @: ...

    Started by Mc-Key‎, Jan 4th, 2018 08:26 AM
    embedded power, epower, tle9844, tle9845, tle984x, tle9869, tle986x, tle9879, tle987x
    • Replies: 0
    • Views: 10,881
    Jan 4th, 2018, 08:26 AM Go to last post
  1. Programming problem XC2060N-40F80l

    Hi My question is how to program the XC2060N-40F80l microcontroller with the DAP miniWiggler programmer. Is it possible to program this IC with...

    Started by parsapournabiii‎, Sep 13th, 2021 10:17 PM
    dap miniwiggler
    • Replies: 1
    • Views: 351
    Today, 09:31 AM Go to last post
  2. Software does not run without debugger

    We observed that our code is working correctly with debugger. It rotates motor correctly. But when we remove debugger it doesnt Working. Motor does...

    Started by Roshan‎, Aug 25th, 2021 09:20 AM
    debugger, tle986x
    • Replies: 2
    • Views: 756
    Sep 13th, 2021, 05:06 AM Go to last post
  3. TLE9879 undesirable Wake-Up with wAKE_STATUS=0

    Hello, I have some problems with TLE9879 but most important is PMU wake ups. I configured PMU to wake up on falling edge of P0.1. But when...

    Started by George‎, Sep 6th, 2021 08:51 AM
    tle9879 wake-up
    • Replies: 2
    • Views: 414
    Sep 9th, 2021, 10:52 PM Go to last post
  4. TLE9877 - Custom board , APP not working after Hard reset.

    Hello, In our project, we are using TLE9877 integrated to our ECU (Electronic Control Unit) to spin BLDC motor. To flash our ECU, we are using...

    Started by smita‎, Sep 14th, 2020 03:03 AM
    hard reset, tle987x
    • Replies: 1
    • Views: 2,687
    Sep 9th, 2021, 01:54 AM Go to last post
  5. TLE9879 PWM Interface examples

    Hello, the HW Design Guide for the TLE987x describes a PWM interface in addition to the LIN-Bus: Does anybody have any experience using this...

    Started by jgerhardy‎, Aug 13th, 2021 03:24 AM
    • Replies: 4
    • Views: 1,396
    Sep 6th, 2021, 03:03 AM Go to last post
  6. Tle9862 controller shows overcurrent issue

    Tle9862 controller shows overcurrent and shutdown bridge driver even there is no load. We have custom board has followed all designing details and...

    Started by Roshan‎, Aug 25th, 2021 09:00 AM
    bridge driver ic, overcurrent, tle986x
    • Replies: 1
    • Views: 642
    Sep 5th, 2021, 11:24 PM Go to last post
  7. TLE9879 / BLDC FOC sensorless / Motor not restart after Stop

    Hello, Currently i am using BLDC Foc sensorless example with TLE9879 evaluation kit to drive my BLDC motor To run the motor, i send command with a...

    Started by M_BENDR‎, Aug 17th, 2020 12:33 AM
    • Replies: 1
    • Views: 3,281
    Sep 2nd, 2021, 11:39 PM Go to last post
  8. TLE987x UART2 TX Interrupt example

    Hello, Is there any example code for implementing Tx interrupts using UART2? I don't fully understand how to correctly handle UART2.SCON.TI bit ...

    Started by ivernot‎, Jul 10th, 2021 12:24 AM
    • Replies: 1
    • Views: 627
    Aug 24th, 2021, 12:27 AM Go to last post
  9. Error occurred when I writing BLDC_Sensorless_FOC Example to TLE9879QXW40

    thats any kind of Error for my first day ............. help me, lord! its just a Example, how can this be so hard!

    Started by q2213010‎, Jul 19th, 2021 11:31 AM
    2 Pages
    1 2
    • Replies: 12
    • Views: 7,009
    Aug 18th, 2021, 04:14 AM Go to last post
  10. Timer21 Example

    I am looking to create a speed output clock, and am having problems getting Timer21 activated to create such a clock on P0.3 on a TLE9879. I have...

    Started by zcab911‎, Jul 26th, 2021 07:44 PM
    • Replies: 3
    • Views: 3,356
    Aug 10th, 2021, 10:15 AM Go to last post
  11. Looking for Documentation for BLDC BEMF TLE987X v1.5.0

    Hello, Can someone please point me to more detailed information on the example 'BLDC_BC_BEMF_EXAMPLE_TLE987X_1.5.0' (which can be found as part of...

    Started by ivernot‎, Jul 22nd, 2021 11:01 PM
    app notes, bemf, example code, tle987x
    • Replies: 7
    • Views: 4,693
    Aug 10th, 2021, 10:10 AM Go to last post
  12. TLE9879 How to set stack size

    Hello, I would like to know/change the stack size for my application (which was originally based on Infineon sample project) (I am using Keil V6 C...

    Started by ivernot‎, Jul 14th, 2021 12:39 AM
    • Replies: 2
    • Views: 5,681
    Jul 16th, 2021, 04:22 PM Go to last post
  13. TLE9877 - Input voltage for XTAL 1 with External Oscillator

    Hi, I'm a bit confused by the datasheet for the TLE9877QTW40. The pin P2.0 / XTAL1 is listed in section 29.5.3 (DC parameters of Port 2) as being...

    Started by markbt‎, Jul 8th, 2021 01:01 AM
    • Replies: 1
    • Views: 4,868
    Jul 16th, 2021, 08:22 AM Go to last post
  14. TLE9877 - Default State of Port 0.0 (SW_CLK) After Software Reset

    Hi, I'm using TLE9877 MCU. I found that the logic of Port 0.0 (pin 21) was high by default after software reset. This pin is a SWCLK. I have to...

    Started by Infineon_User‎, Jun 24th, 2021 09:40 PM
    • Replies: 1
    • Views: 3,829
    Jul 1st, 2021, 08:28 AM Go to last post
  15. TLE9867QXW20 PLL freerunning mode

    Hi. I used STOP mode at TLE9867. In device pack 1.4.6 was changed enter in STOP mode, PLL go to freerunning mode. After STOP PLL not returns at...

    Started by fromak‎, Feb 9th, 2021 02:03 AM
    • Replies: 1
    • Views: 4,239
    Jun 24th, 2021, 06:22 AM Go to last post
  16. BLDC Shield with TLE9879QXA40 for Arduino

    Hey if anyone worked on BLDC Shield with TLE9879QXA40 please replay me

    Started by varun‎, Apr 1st, 2021 11:03 PM
    • Replies: 1
    • Views: 4,576
    Jun 24th, 2021, 06:19 AM Go to last post
  17. Microcontroller TLE9879QXA40

    Hi, Is anyone working with the microcontroller TLE9879QXA40 for the BLDC Motor application? I Need some help, I will be grateful if anyone...

    Started by sai krishna‎, Jul 14th, 2017 02:40 AM
    • Replies: 7
    • Views: 11,322
    Jun 24th, 2021, 06:13 AM Go to last post
  18. Not enough information available to develop SWD Flash solution for TLE9862

    TLE98XX Flash Programming Through SWD I am attempting to develop an SWD solution that will erase and program the flash of a TLE9862. I have the...

    Started by dhiller‎, Jun 3rd, 2021 07:00 AM
    boot rom, flash, swd, tle986x
    • Replies: 0
    • Views: 261
    Jun 3rd, 2021, 07:00 AM Go to last post
  19. TLE9879 Connectors

    Hi all, I just received my BLDC Shield TLE9879, and I'm wondering what is the easiest way to connect power, phases, and hall sensors? I can simply...

    Started by Shay2b1‎, May 28th, 2021 12:02 AM
    connector, connectors, tle9879
    • Replies: 2
    • Views: 2,221
    May 31st, 2021, 07:22 AM Go to last post
  20. BEMF Parameters in Sensorless FOC application

    I am running a lower power BLDC 4-pole motor using the TLE9879 Arduino Bridge in standalon mode now. I have had the motor working will when running...

    Started by zcab911‎, Apr 6th, 2021 03:38 PM
    • Replies: 1
    • Views: 5,114
    Apr 16th, 2021, 06:32 PM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Tag Cloud

Disclaimer

All content and materials on this site are provided “as is“. Infineon makes no warranties or representations with regard to this content and these materials of any kind, whether express or implied, including without limitation, warranties or representations of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, whether express or implied, is granted by Infineon. Use of the information on this site may require a license from a third party, or a license from Infineon.


Infineon accepts no liability for the content and materials on this site being accurate, complete or up- to-date or for the contents of external links. Infineon distances itself expressly from the contents of the linked pages, over the structure of which Infineon has no control.


Content on this site may contain or be subject to specific guidelines or limitations on use. All postings and use of the content on this site are subject to the Usage Terms of the site; third parties using this content agree to abide by any limitations or guidelines and to comply with the Usage Terms of this site. Infineon reserves the right to make corrections, deletions, modifications, enhancements, improvements and other changes to the content and materials, its products, programs and services at any time or to move or discontinue any content, products, programs, or services without notice.