MOTIX™ MCU Forum Discussions
Dear team I need to wakeup MCU once its go below 3V, using LIN wakeup, if any sample code/ or configuration is available please let us know.
大家好 请问有没有关于TLE9879的CSA例程,BLDC电机控制里想加一个电流检测,官方例程里没有关于CSA的例子,希望有使用过这个功能的分享一下经验。 谢谢!
Hello,
I'm buying the TLE9879 from Digikey, do they come with pre-programmed BLDC Driver? (same as the one on the Arduino shield).
If not, where can I order pre-programmed chip?
Thanks in advance.
Best,
Thai.
Show LessHi,
I am using a malloc and calloc functionality for a DAQ implementation purpose. I am using TLE9893 series chip . the code compile well but seems to stuck while in debug mode on calloc and malloc function. I tried to set heap size to 16K but didnt work. Any suggestions/alternative method of using this. !!
I am not looking for any optimistic memory allocation, just need a basic memory allocation method.
Thanks
Prakash
Show LessHi,
I am trying to implement a RTC timestamp in the TLE9893 series. Can you give us a idea or example source project for a basic RTC example
Thanks
Prakash
Show LessHi
One of my client is looking for flush door handle to drive 12V/1A motor with minimal circuitry using full bridge topology & required inbuilt LDO / LIN Communication & if mosfet inbuilt will be better.
I have chosen TLE9853QX + IPG20N04S4-18A to support here. Any other recommendation let me know.
Regards
Lucky Kumar
Show Less
TLE9893新建工程生成的Config Wizard配置文件,用Config Wizard打开时提示“Cannot open file "TLE989x.svd" used in >svd/>
ADC1 or ADC2 get val has been filtered ADC1_GetChResult
smartconx_target@Q!w2e3r4t5y6u7i8o9p0||/t5/MOTIX-MCU/TLE9877-ADC%E6%BB%A4%E6%B3%A2/td-p/737950
Show Less