MOSFET (Si/SiC) Forum Discussions
I would like to know if the solid state relay RDHA710SE10A2FK can conduct bipolar currents for an AC application.
Any suggestion for a SPICE model is also very welcome.
Show LessHello everyone,
I am seeking out for an information whether X-ray inspection can have an adverse impact on AIKB50N65DF5ATMA1 functionality. I plan to do such inspection on 1000 assemblies but I am not sure if this, can cause any breakdown. I have already studdy IPC-610-H but found nothing helpful. Is tere any maximum of radiation that electonic can survive. Can anyone help me out on this ?
Regards,
Simon
Show Less
Does anyone know the reverse recovery time of the IQE006NE2LM5CGSC? The datasheet doesn't show it, is there a#IQE006NE2LM5CGSCny other way to know?
Show Less请问有人知道IQE006NE2LM5CGSC 的反向恢复时间吗? datasheet上面并没有显示,请问有别的方法知道吗
IQE006NE2LM5CGSC
smartconx_target@Q!w2e3r4t5y6u7i8o9p0||/t5/MOSFET-Si-SiC/%E8%AF%A2%E9%97%AE%E5%85%B3%E4%BA%8EIPP023N08N5-DS-v02-00-EN%E5%9E%8B%E5%8F%B7%E7%9A%84%E7%83%AD%E6%8D%9F%E8%80%97/td-p/715973
Show LessDear IFXer,
As far as I know, the nonlinear Coss of SJ MOSFET is caused by the depletion region between the p-pillar and the epitaxial n-layer on the drain-source voltage
and would like to know what the nonlinear Coss behavior is in SiC MOSFETs, including both planar and trench of gate structures?
Show Less
Where can I find component mass estimates? Is there an accessible archive of Material Declarations for Infineon components?
Specifically looking for IRLR3110ZTRPBF but would be good to know where to get them in the future.
Show LessHi Infineon Team; IC, BGS13SN8E6327XTSA1 Recommended control signal voltage range 1.35~3.6V according to datasheet (Vdd is a 3.3V power supply), please help to confirm if there is any reliability risk in the application if the voltage of the control signal is 5V? Thank you.
smartconx_target@Q!w2e3r4t5y6u7i8o9p0||/t5/MOSFET-Si-SiC/BGS13SN8E6327XTSA1%E7%94%B5%E5%8E%8B%E8%8C%83%E5%9B%B4%E9%A3%8E%E9%99%A9/td-p/713095
Show LessWhen MOSFET driving resistive load current and voltage changes instantaneously but for inductive load why MOSFET voltage VDS gets clamped ??
Hello IFXer,
Do you have any NTC calcuation tool for F4-17MR12W1M1H_B76 can provide to me? thank you.