infineon4engi@twitter twitter

infineon4engineers Facebook

infineon@linkedin linkedin

infineon@youtube youtube


+ Post New Thread
Page 1 of 11 1 2 3 4 5 ... LastLast
Threads 1 to 20 of 211

Forum: General Forum

General Forum

  1. 24GHz automotive radar development kit - Unreliable measurements

    Hello, I am using the 24GHz automotive radar kit. The measurements returned by the radar kit for the distance, speed, angle and RCS seem to be...

    Started by pranav‎, Mar 14th, 2017 04:52 AM
    2 Pages
    1 2
    • Replies: 12
    • Views: 6,317
    Jun 7th, 2017, 01:58 AM Go to last post
  2. PROFET for Proportional Valves

    Hello, I have visited and posted to these forums many times with great success for help with the XMC4500 so I figured I would try to get some help...

    Started by adambriz88‎, May 2nd, 2014 10:48 AM
    2 Pages
    1 2
    • Replies: 11
    • Views: 20,738
    May 16th, 2014, 06:03 AM Go to last post
  3. Tle5012b e1000

    Hello :) I would like to interface the TLE5012B E1000 with the SPI interface of a PIC32 Microcontroller. Now, I am a bit confused because of the...

    Started by chriz3dd‎, Feb 24th, 2014 07:32 AM
    • Replies: 9
    • Views: 18,855
    Jul 13th, 2018, 11:31 AM Go to last post
  4. TLI4970-D050T4 measurements precision.

    I start work with this current sensor. I use TLI4970050 EV-BOARD. I remove all 0 Ohm resistors attached to TLI4970 and connect TLI to own board ...

    Started by karmer‎, Nov 7th, 2014 12:55 AM
    • Replies: 9
    • Views: 15,325
    Dec 9th, 2015, 02:44 AM Go to last post
  5. High side switches reverse battery protection

    Hi everybody, I see that the Infineon smart high side switches provide battery reverse protection, by connecting a 150 ohm resistor in GND as a...

    Started by suly‎, Dec 20th, 2015 01:47 AM
    • Replies: 8
    • Views: 5,524
    Apr 4th, 2016, 04:27 AM Go to last post
  6. How should I implement

    In my previous thread i understood the explanation of bsp752r which I am using in my project. My question is generally we enable the bsp752r by...

    Started by eleclearner‎, Feb 9th, 2016 08:48 AM
    • Replies: 8
    • Views: 3,917
    Oct 15th, 2016, 06:42 PM Go to last post
  7. Tle5206

    I would like to use the TLE5206 to control a DC motor without PWM. I merely want to start, stop, and reverse the motor. I set up the circuit shown on...

    Started by Rich‎, Feb 9th, 2012 05:01 AM
    • Replies: 6
    • Views: 10,485
    May 1st, 2012, 07:00 AM Go to last post
  8. TDA5235 SPI Interface Problem

    hi, I am working on TDA5235 Receiver in my project. I interfaced it with SPI. Using SPI i am able Transferring Data from my controller. But i am...

    Started by cnu123‎, Aug 29th, 2013 11:58 PM
    • Replies: 6
    • Views: 6,347
    Sep 5th, 2013, 01:45 AM Go to last post
  9. Datasheet EUPEC FM35R12KE3ENG

    Hello everyone, My name is Nhan, I'm a student in University of Ulsan. I have a EUPEC IGBT Modules for Matrix Converter with device name: EUPEC...

    Started by khiconv2‎, Aug 29th, 2012 12:41 AM
    • Replies: 6
    • Views: 12,383
    Apr 5th, 2017, 06:41 AM Go to last post
  10. TLE5012B. CRC calculation trouble.

    Hello! I am using TLE5012B via SSC interface (bit bang mode, not hardware spi, connection according to the datasheet). I write to sensor command...

    Started by alek‎, Sep 3rd, 2018 10:52 PM
    • Replies: 6
    • Views: 2,772
    Feb 18th, 2019, 07:21 AM Go to last post
  11. Compiler to use for the TLE9833 microcontroller

    Can anyone recommend a compiler to use for the TLE9833 part? I have been quoted for the CA51-LC and the PK51-LC compilers. The PK51 professional...

    Started by Donal‎, May 21st, 2015 03:59 AM
    • Replies: 5
    • Views: 6,341
    Dec 2nd, 2015, 04:14 AM Go to last post
  12. How to set the working mode with SICI interface of TLI4970,such as TLI4970D025T5?

    I want to use it in my design,but the datasheet of TLI4970D025T5 doesn't give the programing ways of its EEPROM which is essential for seting the...

    Started by lsj306‎, Nov 26th, 2015 06:02 AM
    tli4970
    • Replies: 5
    • Views: 4,869
    Jan 18th, 2016, 02:58 AM Go to last post
  13. Temperature Sensor of BGT24MTR11 -- wrong transfer function equation

    Hi all, In the document "BGT24MTR11 Appllication Note AN305 User 's Guide to BGT24MTR11 24 GHz Radar", page 13, figure 8 shows the transfer...

    Started by Jhon‎, Dec 14th, 2017 06:10 AM
    • Replies: 5
    • Views: 2,944
    Jun 7th, 2018, 04:31 AM Go to last post
  14. TLV493D returns NCK

    Hi, I'm using a TLV493D with a power separated by FET from microcontroller power, like Slave #1 in figure 14 of I2C interface note...

    Started by aquahika‎, Feb 1st, 2018 02:55 AM
    • Replies: 5
    • Views: 4,239
    Mar 1st, 2018, 02:35 AM Go to last post
  15. Pspice model problems

    Hi, I'm trying to simulate the IKW40N120H3 IGBT using Capture/PSpice 16.5, and I get the following error message ERROR(ORPSIM-15108):...

    Started by Guz21‎, Feb 2nd, 2012 02:16 PM
    model, pspice
    • Replies: 4
    • Views: 18,732
    Mar 18th, 2012, 11:30 PM Go to last post
  16. TLE5206 Short Circuiting

    I have a TLE5206 that I am trying to use to drive a small linear actuator. The actuator draw's 0.5A normally, and It stalls at aprox 4A. I am driving...

    Started by zryder94‎, May 31st, 2013 01:26 PM
    • Replies: 4
    • Views: 7,721
    Jun 10th, 2013, 02:55 AM Go to last post
  17. where can I find the driver for PEB2256

    recently ,I have do some work with TDM,and i want to the E1 ,which can produce by PEB2256,and iwant to the C driver for this chip. can I have...

    Started by wu ji hua‎, Jul 8th, 2015 07:31 AM
    peb2256 e1
    • Replies: 4
    • Views: 4,934
    Jul 26th, 2015, 11:57 PM Go to last post
  18. Radar

    It appears Infineon has a great 60ghz if for gesture recognition. How can we find and get information about this? We like to design this for which...

    Started by ba2‎, Apr 4th, 2016 07:51 PM
    radar
    • Replies: 4
    • Views: 4,368
    Oct 3rd, 2016, 04:52 PM Go to last post
  19. TLV493D acknowledge problem

    I'm currently testing out a TLV493D magnetic sensor on an arduino. I think I have some problems with the acknowledge bit. It does not pull completely...

    Started by potatocheese‎, Oct 14th, 2017 04:40 AM
    • Replies: 4
    • Views: 2,991
    Mar 1st, 2018, 05:29 AM Go to last post
  20. EVAL BGT24LTR11 BOARD FMCW mode

    Hello, I am working with the EVAL BGT24LTR11 BOARD. It works fine in Doppler mode but I am noticing some problems when configured to FMCW mode. I...

    Started by emacar‎, May 29th, 2019 05:17 AM
    eval bgt24ltr11 board, fmcw, radar, radar 24ghz, radar24ghz
    • Replies: 4
    • Views: 2,530
    Jun 17th, 2019, 01:32 AM Go to last post

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread
Disclaimer

All content and materials on this site are provided “as is“. Infineon makes no warranties or representations with regard to this content and these materials of any kind, whether express or implied, including without limitation, warranties or representations of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, whether express or implied, is granted by Infineon. Use of the information on this site may require a license from a third party, or a license from Infineon.


Infineon accepts no liability for the content and materials on this site being accurate, complete or up- to-date or for the contents of external links. Infineon distances itself expressly from the contents of the linked pages, over the structure of which Infineon has no control.


Content on this site may contain or be subject to specific guidelines or limitations on use. All postings and use of the content on this site are subject to the Usage Terms of the site; third parties using this content agree to abide by any limitations or guidelines and to comply with the Usage Terms of this site. Infineon reserves the right to make corrections, deletions, modifications, enhancements, improvements and other changes to the content and materials, its products, programs and services at any time or to move or discontinue any content, products, programs, or services without notice.