+ Post New Thread
Page 1 of 12 1 2 3 4 5 11 ... LastLast
Threads 1 to 20 of 232

Forum: General Forum

General Forum

  1. Position2Go-UART?

    I am attempting to use UART communication between my Arduino and Position2Go sensor. However, I cannot find a pinout diagram of the Position2Go...

    Started by Drago627‎, Mar 24th, 2020 11:24 AM
    position2go, uart
    • Replies: 0
    • Views: 104
    Mar 24th, 2020, 11:24 AM Go to last post
  2. IGBT Discrete banner

    Banner_Discrete-IGBTs-232x232 Discrete-with-Anti-Parallel-Diode-232x232 Discrete-without-Anti-Parallel-Diode-232x232...

    Started by Huixian‎, Mar 17th, 2020 03:27 PM
    • Replies: 0
    • Views: 239
    Mar 17th, 2020, 03:27 PM Go to last post
  3. igbt module banner

    Banner_EconoPack-2_3-232x232 Banner_Easy_Power-Modules-232x232 Easy-with-Trenchstop-igbt7-232x232 Banner_Thermal-Interface-Material-232x232...

    Started by Huixian‎, Mar 17th, 2020 03:02 PM
    • Replies: 0
    • Views: 244
    Mar 17th, 2020, 03:02 PM Go to last post
  4. TLE5012B rotation direction change angle error 1 degree?

    Understood. Close it.

    Started by ericfu‎, Mar 6th, 2020 08:45 PM
    • Replies: 0
    • Views: 503
    Mar 6th, 2020, 08:45 PM Go to last post
  5. TLE82453 setpoint value

    hello all Greeting for the day, i am working on TLE82453 chip set device for controlling the load and the micro controller i am using to communicate...

    Started by deepakseshan1‎, Feb 26th, 2020 08:33 AM
    • Replies: 0
    • Views: 518
    Feb 26th, 2020, 08:33 AM Go to last post
  6. IGBT module f4-75r06w1e3 for a three phase inverter application

    We are using IGBT module f4-75r06w1e3 for a three phase inverter application. We have well tested gate driver based on IR2110 wich is isolated by...

    Started by mathespbe‎, Jan 11th, 2015 09:01 PM
    • Replies: 2
    • Views: 4,331
    Feb 21st, 2020, 04:28 AM Go to last post
  7. Application RF Switch BGS14PN10

    Hello I going to use BGS14PN10 and LTE modem with output RF power 23 dBm (23 dBm up to 3.5V RMS on 50 Ohm) . I chose the power suplay 1.8 V for...

    Started by Dmtriy‎, Feb 18th, 2020 10:25 PM
    • Replies: 0
    • Views: 362
    Feb 18th, 2020, 10:25 PM Go to last post
  8. Is it possible to extract the raw data in C of both antenas in different arrays

    Hello, I'm using the P2GO radar, and I'm trying to acces to both antennas raw data in C. What I've came across is the next code, but it doesnt...

    Started by Yassine‎, Feb 18th, 2020 04:50 AM
    extract_raw_data, position2go, radar 24ghz
    • Replies: 1
    • Views: 381
    Feb 18th, 2020, 05:07 AM Go to last post
  9. Best radar for object detection

    Hello, I would like to make people/object detection system for a vehicle. Idea is to detects people when the vehicle is going in reverse. That...

    Started by Martinizhr91‎, Feb 10th, 2020 04:20 PM
    detection, object-tracking, position2go, radar
    • Replies: 1
    • Views: 466
    Feb 17th, 2020, 12:45 PM Go to last post
  10. TDA5150 PLL error

    Hi All. I tuned the registers according to the set frequency in TESEUS. XTAL 13.56 MHz out freq: 868.4 MHz ISM - 2 PLL INT - 63 PLL FRAC 2:...

    Started by andrvisht‎, Jan 5th, 2020 02:14 PM
    • Replies: 1
    • Views: 861
    Feb 12th, 2020, 12:00 AM Go to last post
  11. Bgt24mtr11

    Can the internal 'register' (the states set by SPI) in the device be read out across SPI; if so how? TIA

    Started by BDVS‎, Feb 3rd, 2020 05:52 AM
    24ghz mmic, bgt24mtr11
    • Replies: 0
    • Views: 717
    Feb 3rd, 2020, 05:52 AM Go to last post
  12. TLE5012B in bus mode

    In my application, I need to use four TLE5012, read through SPI. Four chips, I use 1 CLK, 1 DATA, 4 CS connections. A single one can be used...

    Started by tannix‎, Jan 22nd, 2020 08:25 AM
    • Replies: 2
    • Views: 744
    Feb 2nd, 2020, 03:42 AM Go to last post
  13. I2C Communication with TLE493DW2B6

    Good day, I've been trying without success to communicate with my TLE493D devices (I have the A0). When I scan the I2C bus using a Raspberry Pi...

    Started by pvint‎, Jan 29th, 2020 02:08 PM
    • Replies: 0
    • Views: 471
    Jan 29th, 2020, 02:08 PM Go to last post
  14. Endorsement key certificate (SLB96702.0)

    Hi. I've got the following device: OPTIGA™ TPM SLx 9670 TPM2.0 with SPI Interface in a Raspberry Pi 3...

    Started by artemkamov‎, Jan 28th, 2020 01:02 AM
    • Replies: 0
    • Views: 589
    Jan 28th, 2020, 01:02 AM Go to last post
  15. D2G board sample duration

    Hi, I am using D2G board (doppler mode) to extract raw data to matlab for processing. Using the function provided, I can get the 256 points IQ...

    Started by singsing_tsang‎, Dec 23rd, 2019 11:06 PM
    • Replies: 1
    • Views: 845
    Jan 27th, 2020, 03:25 PM Go to last post
  16. Tle9273 unable to send data to the micro controller through SPI communication

    I am using SBC (tle9273) as the slave which communicates to RH850F1KHD8 microcontroller (Master) through SPI communication. When I send a command...

    Started by Sahithi‎, Jan 7th, 2020 10:14 PM
    • Replies: 1
    • Views: 786
    Jan 20th, 2020, 11:10 PM Go to last post
  17. Hall-Effect Detection

    Dear Hall Sensor team We changed VS Voltage 12V to 5V as a attach file that is TLV4996K_VS. It has happened strange waveform as a attach file...

    Started by geraldchoi‎, Jan 12th, 2020 06:40 PM
    • Replies: 1
    • Views: 603
    Jan 20th, 2020, 10:59 PM Go to last post
  18. ISO1H816G SPI communication problem (important)

    Hi, I have a ISO1H816G entegre. I could not communicate with this device in any way. I use the Tiva TM4C1231D6PZ as a microcontroller. When I...

    Started by aliyolcu28‎, Jan 13th, 2020 03:26 AM
    • Replies: 6
    • Views: 1,194
    Jan 17th, 2020, 03:01 AM Go to last post
  19. CC control with XMC4200-F64k256AB

    Great work with the EVAL_3K3W_BIDI_PSFB kit! I would like to test the FSFB topology for a battery charger. This will require Constant current...

    Started by TarunBajaj‎, Jan 16th, 2020 02:38 AM
    • Replies: 0
    • Views: 575
    Jan 16th, 2020, 02:38 AM Go to last post
  20. Diable outputs ISO1H812G

    Hello! I'm usign ISO1H812G as output unit in SPI communication. I've implemented a function for error detection that set a variable if MISO and MOSI...

    Started by Janet‎, May 10th, 2019 05:00 AM
    • Replies: 3
    • Views: 1,949
    Jan 14th, 2020, 01:18 AM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Tag Cloud


All content and materials on this site are provided “as is“. Infineon makes no warranties or representations with regard to this content and these materials of any kind, whether express or implied, including without limitation, warranties or representations of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, whether express or implied, is granted by Infineon. Use of the information on this site may require a license from a third party, or a license from Infineon.

Infineon accepts no liability for the content and materials on this site being accurate, complete or up- to-date or for the contents of external links. Infineon distances itself expressly from the contents of the linked pages, over the structure of which Infineon has no control.

Content on this site may contain or be subject to specific guidelines or limitations on use. All postings and use of the content on this site are subject to the Usage Terms of the site; third parties using this content agree to abide by any limitations or guidelines and to comply with the Usage Terms of this site. Infineon reserves the right to make corrections, deletions, modifications, enhancements, improvements and other changes to the content and materials, its products, programs and services at any time or to move or discontinue any content, products, programs, or services without notice.