infineon4engi@twitter twitter

infineon4engineers Facebook

infineon@linkedin linkedin

infineon@youtube youtube

+ Post New Thread
Page 1 of 6 1 2 3 4 5 ... LastLast
Threads 1 to 20 of 115

Forum: Technical Center

This is the technical center. Please share your photos, application, hobby project here.

  1. Oscillator monitor alarm reported on correct configuration.

    Hi All, I am working on TC387 micro and configuring the Oscillator watchdog to monitor the crystal oscillator. After configuring the correct...

    Started by‎, Dec 4th, 2019 02:52 AM
    • 45
    Dec 4th, 2019, 02:52 AM Go to last post
  2. GATe driver for MOSFET controlling of PMSM motor

    hey guts I am working with IR 2110 gate to control my mosfet which is controling my PMSM . while i am trying to do this it gives me lot of error...

    Started by NeelShah7‎, Nov 27th, 2019 02:03 AM
    • 55
    Nov 27th, 2019, 02:03 AM Go to last post
  3. Reset in TC265

    PORST pin in TC265 is pulled low at random cases. This is not handled in the SW. The uC pulls it low which resets in Watchdog reset What are all...

    Started by AMIRTHAVARSHINI‎, Nov 18th, 2019 02:22 AM
    • 54
    Nov 18th, 2019, 02:22 AM Go to last post
  4. KIT_AURIX_TC264_TRB Debugging with Windriver Workbench 4

    Hello All, We are trying to debug the TC264 TriBoard (Aurix) using WindRiver Workbench 4 (Eclipse Version: 4.7.3) using the On board debugger on...

    Started by harshajk‎, Oct 23rd, 2019 03:48 AM
    aurix, tc264, triboard tc264
    • 270
    Nov 14th, 2019, 09:56 AM Go to last post
  5. XMC 4300 Ethercat Dave Manual Pin Allocator

    Hi, I am just starting with the XMC 4300 Ethercat Dave example from here...

    Started by lemmi25‎, Oct 29th, 2019 03:40 AM
    • 181
    Oct 29th, 2019, 03:40 AM Go to last post
  6. How to judge MCU reset? Check one pin or register of MCU to see if ECU reset

    Requirement :I need to count the number of ECU resets under abnormal conditions. Solution:Total number of resets - number of normal resets = number...

    Started by 王晓宁‎, Oct 28th, 2019 06:52 PM
    mcu reset counter
    • 188
    Oct 28th, 2019, 06:52 PM Go to last post
  7. Need ClassD amplifier for 60 Hz transformer switching

    Hello Sir, My intention is to make an 3-phase power calibrator, I was looking for a ClassD...

    Started by Hasan2019‎, Oct 18th, 2019 02:47 AM
    • 248
    Oct 18th, 2019, 02:47 AM Go to last post
  8. ADC on XMC4400

    Hi there On my circuit, i get a differential signal, which I want to connect to one of the ADCs on the XMC4400 MCU. As far as I figuered out, one...

    Started by Andy‎, Oct 13th, 2019 08:46 AM
    adc, differential signal, single ended, xmc4400
    • 307
    Oct 13th, 2019, 08:46 AM Go to last post
  9. the sp37 was lock

    we make a mistake in sp370 program, and we lock the IC. Now we want to unlock the IC, we try to enter test mode(when the sp370 lock,we can not enter...

    Started by zheng‎, Oct 11th, 2019 09:40 PM
    pressure, sp37
    • 237
    Oct 11th, 2019, 09:40 PM Go to last post
  10. Interfacing IMC101T-T038 with Arduino Uno

    Hello Everyone, I want to interface IC IMC101T-T038 with Arduino Uno. How can I use interface pins of IMC101T-T038 with Arduino Uno? (...

    Started by Sourabh‎, Oct 1st, 2019 04:22 AM
    • 300
    Oct 1st, 2019, 04:22 AM Go to last post
  11. Auto Code Generator tool for AUDO MAX familly's TC1793 controller

    Hello, We are using TC1793 TRICORE, I need to initialize the auto-code generator tool for this for the driver initialisation of the ...

    Started by anurag‎, Sep 25th, 2019 12:29 PM
    • 361
    Sep 25th, 2019, 12:29 PM Go to last post

    Hello Sir/Madam, We had ordered the KIT_AURIX_TC265_TFT (OPN: KITAURIXTC265TFTTOBO1) from the Infineon and now, we are unable to flash the hex...

    Started by Rajasekhar‎, Sep 24th, 2019 07:26 AM
    • 239
    Sep 24th, 2019, 07:26 AM Go to last post
  13. Want to interface flash via SPI in XMC4800 (Using Api)

    Working on automation board (XMC4800), I want to configure SPI protocol to communicate flash.I have already configured the pins using APP now just...

    Started by Subhash07‎, Sep 18th, 2019 12:58 AM
    xmc 4800
    • 296
    Sep 18th, 2019, 12:58 AM Go to last post
  14. Bifaces to Hightec Managed project migration - Aurix TC277

    Hello, I am following the document Bifaces to Hightec Migration I have encountered some issues. The first part from the document (Migrate iLLD)...

    Started by deepakseshan1‎, Sep 15th, 2019 12:07 PM
    • 334
    Sep 15th, 2019, 12:07 PM Go to last post
  15. XC164CM U CAN start kit and files for AP32136

    I am in dire need of an XC164CM U CAN start kit and also the files listed in chapter 7 of application note 32136. Can anyone part with one of the...

    Started by‎, Aug 28th, 2019 08:34 AM
    ap32136, xc164cm ucan
    • 451
    Aug 28th, 2019, 08:34 AM Go to last post
  16. KIT_AURIX_TC297_TRB with TC297TA derivative

    Hi, Which MCAL version does it supports ? Provided MCAL version will be compatible with Elektrobit BSW Stack 4.2.1 ?

    Started by bhupesh‎, Aug 8th, 2019 03:31 AM
    • 456
    Aug 8th, 2019, 03:31 AM Go to last post
  17. ILD6150 ILD6070 Internal shunt resistor values

    Hi. I would like to known, if possible, which are the shunt resistor values used on the internal OCP circuit of ILD6150/ILD6070 products. Regards.

    Started by iggardo‎, Aug 7th, 2019 04:48 AM
    • 357
    Aug 7th, 2019, 04:48 AM Go to last post
  18. TLE9879QXW40 , bridge driver high side gh1 , gh2 ,by default high using in PWM mode .

    I am using TLE9879QXA40 for development . I configured ccu6 for three phase pwm generation and bridge driver in pwm mode . I am able to see PWM...

    Started by alok‎, Jul 31st, 2019 11:31 PM
    • 368
    Jul 31st, 2019, 11:31 PM Go to last post
  19. TLE9263-3BQX question

    TLE9263-3BQX 配置 问题 1 .How to configure CAN SWK Mode (WUF)or Configuration sequence? 问题2 . How to enable and close the...

    Started by 也好‎, Jul 12th, 2019 12:53 AM
    • 441
    Jul 12th, 2019, 12:53 AM Go to last post
  20. Old datasheet TLE5711G - long shot

    Hi, Does anyone have a datasheet for the TLE5711G device? It's an automotive component that was discontinued in 2003 :( Thanks in advance.

    Started by Trebor‎, Jul 10th, 2019 05:05 AM
    • 370
    Jul 10th, 2019, 05:05 AM Go to last post

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

All content and materials on this site are provided as is. Infineon makes no warranties or representations with regard to this content and these materials of any kind, whether express or implied, including without limitation, warranties or representations of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, whether express or implied, is granted by Infineon. Use of the information on this site may require a license from a third party, or a license from Infineon.

Infineon accepts no liability for the content and materials on this site being accurate, complete or up- to-date or for the contents of external links. Infineon distances itself expressly from the contents of the linked pages, over the structure of which Infineon has no control.

Content on this site may contain or be subject to specific guidelines or limitations on use. All postings and use of the content on this site are subject to the Usage Terms of the site; third parties using this content agree to abide by any limitations or guidelines and to comply with the Usage Terms of this site. Infineon reserves the right to make corrections, deletions, modifications, enhancements, improvements and other changes to the content and materials, its products, programs and services at any time or to move or discontinue any content, products, programs, or services without notice.