infineon4engi@twitter infineon@linkedin infineon4engineers infineon@youtube
twitter Facebook Linkedin Youtube

+ Post New Thread
Page 1 of 7 1 2 3 4 5 ... LastLast
Threads 1 to 20 of 125

Forum: Technical Center

This is the technical center. Please share your photos, application, hobby project here.

  1. Tle 6228 gp

    En(Enable) Pin is high STBY(Standby) Pin is high Input Pin is low Output is short circuit to ground If the IC is set to the above conditions the...

    Started by sarthak‎, Today 01:53 AM
    • 2
    Today, 01:53 AM Go to last post
  2. IRFP7530PBF Current Issue

    I have a DC load circuit using IRFP7530PBF. It is simple design as follow: - The gate of the MOSFET have a 10K resistor to ground and a DAC (Digital...

    Started by facruz‎, Feb 21st, 2020 06:54 AM
    • 74
    Feb 21st, 2020, 06:54 AM Go to last post
  3. Cannot simulate the .lib file of TLE4253 in Simetrix

    Need an un-encrypted (working) spice model of TLE4253 to simulate in Simetrix. While simulating in simetrix , I received the below error. " ...

    Started by adithya‎, Feb 21st, 2020 12:05 AM
    • 59
    Feb 21st, 2020, 12:05 AM Go to last post
  4. How to send TPM1.2 commands from SAME51 controller to the SLB9670VQ1.2

    Hi all, I have a SAME51 controller and SLB9670VQ1.2 TPM chip. I have gone through the TPM Main Specification , TPM Integration Specification...

    Started by shaiknisarahmed‎, Feb 18th, 2020 10:47 PM
    slb9670vq1.2, tpm1.2
    • 50
    Feb 18th, 2020, 10:47 PM Go to last post
  5. TLE82453 issue

    Hello, I have assembled TLE82453 as given in the datasheet. I am getting the output but if I switch any electrical device near the module the TLE...

    Started by akshaywale‎, Feb 18th, 2020 05:59 AM
    • 65
    Feb 18th, 2020, 05:59 AM Go to last post
  6. TC234 Application Kit(eMotor Driver Kit)

    Hi, I am trying to compile the example software Ap32298_Application_Example_11 for the motor kit TC234 in Tasking IDE. Is there any instructions,...

    Started by schaul‎, Feb 11th, 2020 03:24 AM
    • 125
    Feb 11th, 2020, 03:24 AM Go to last post
  7. MERUS 1270 x2 clock syncronizing

    Hi MA12070 eval audio boards not being syncronized. My slave unit does not respond as it should. Only noise. Not sure I wired it correctly but I...

    Started by Joffe54‎, Jan 30th, 2020 04:32 AM
    • 158
    Jan 30th, 2020, 04:32 AM Go to last post
  8. Regarding iLLDs for TCx27D

    Hi, will Infineon Support customers if there is any bug or query related to Standard iLLDs provided??

    Started by arjunm4‎, Jan 26th, 2020 11:59 PM
    ccu6, illds, mcal
    • 164
    Jan 26th, 2020, 11:59 PM Go to last post
  9. Optiga Trust M example

    I 've try Optiga trust M example from https://github.com/Infineon/getstarted-optiga-trust-m, it is no problem. But when I create new project and...

    Started by asepthea‎, Jan 16th, 2020 02:04 AM
    optiga trust m
    • 177
    Jan 16th, 2020, 02:04 AM Go to last post
  10. System Basis Chip not responding to data

    Hi, Iam using SBC (TLE 9273) from infeneon. I communicates to my master through SPI protocol. When i try to access any registers from SBC, I...

    Started by Manasa‎, Jan 3rd, 2020 06:28 AM
    basics, chip select, clock, communication, configuration, master, miso, mosi, pin, port, protocol, spi, spi slave, tle9273
    • 345
    Jan 3rd, 2020, 06:28 AM Go to last post
  11. Oscillator monitor alarm reported on correct configuration.

    Hi All, I am working on TC387 micro and configuring the Oscillator watchdog to monitor the crystal oscillator. After configuring the correct...

    Started by mkhirekar@gmail.com‎, Dec 4th, 2019 02:52 AM
    • 302
    Dec 4th, 2019, 02:52 AM Go to last post
  12. GATe driver for MOSFET controlling of PMSM motor

    hey guts I am working with IR 2110 gate to control my mosfet which is controling my PMSM . while i am trying to do this it gives me lot of error...

    Started by NeelShah7‎, Nov 27th, 2019 02:03 AM
    • 279
    Nov 27th, 2019, 02:03 AM Go to last post
  13. Reset in TC265

    PORST pin in TC265 is pulled low at random cases. This is not handled in the SW. The uC pulls it low which resets in Watchdog reset What are all...

    Started by AMIRTHAVARSHINI‎, Nov 18th, 2019 02:22 AM
    • 187
    Nov 18th, 2019, 02:22 AM Go to last post
  14. KIT_AURIX_TC264_TRB Debugging with Windriver Workbench 4

    Hello All, We are trying to debug the TC264 TriBoard (Aurix) using WindRiver Workbench 4 (Eclipse Version: 4.7.3) using the On board debugger on...

    Started by harshajk‎, Oct 23rd, 2019 03:48 AM
    aurix, tc264, triboard tc264
    • 451
    Nov 14th, 2019, 09:56 AM Go to last post
  15. XMC 4300 Ethercat Dave Manual Pin Allocator

    Hi, I am just starting with the XMC 4300 Ethercat Dave example from here...

    Started by lemmi25‎, Oct 29th, 2019 03:40 AM
    • 308
    Oct 29th, 2019, 03:40 AM Go to last post
  16. How to judge MCU reset? Check one pin or register of MCU to see if ECU reset

    Requirement :I need to count the number of ECU resets under abnormal conditions. Solution:Total number of resets - number of normal resets = number...

    Started by 王晓宁‎, Oct 28th, 2019 06:52 PM
    mcu reset counter
    • 330
    Oct 28th, 2019, 06:52 PM Go to last post
  17. Need ClassD amplifier for 60 Hz transformer switching

    Hello Sir, My intention is to make an 3-phase power calibrator, https://us.flukecal.com/products/ele...wer-calibrator I was looking for a ClassD...

    Started by Hasan2019‎, Oct 18th, 2019 02:47 AM
    • 398
    Oct 18th, 2019, 02:47 AM Go to last post
  18. ADC on XMC4400

    Hi there On my circuit, i get a differential signal, which I want to connect to one of the ADCs on the XMC4400 MCU. As far as I figuered out, one...

    Started by Andy‎, Oct 13th, 2019 08:46 AM
    adc, differential signal, single ended, xmc4400
    • 467
    Oct 13th, 2019, 08:46 AM Go to last post
  19. the sp37 was lock

    we make a mistake in sp370 program, and we lock the IC. Now we want to unlock the IC, we try to enter test mode(when the sp370 lock,we can not enter...

    Started by zheng‎, Oct 11th, 2019 09:40 PM
    pressure, sp37
    • 384
    Oct 11th, 2019, 09:40 PM Go to last post
  20. Interfacing IMC101T-T038 with Arduino Uno

    Hello Everyone, I want to interface IC IMC101T-T038 with Arduino Uno. How can I use interface pins of IMC101T-T038 with Arduino Uno? (...

    Started by Sourabh‎, Oct 1st, 2019 04:22 AM
    • 468
    Oct 1st, 2019, 04:22 AM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Tag Cloud

Disclaimer

All content and materials on this site are provided as is. Infineon makes no warranties or representations with regard to this content and these materials of any kind, whether express or implied, including without limitation, warranties or representations of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, whether express or implied, is granted by Infineon. Use of the information on this site may require a license from a third party, or a license from Infineon.


Infineon accepts no liability for the content and materials on this site being accurate, complete or up- to-date or for the contents of external links. Infineon distances itself expressly from the contents of the linked pages, over the structure of which Infineon has no control.


Content on this site may contain or be subject to specific guidelines or limitations on use. All postings and use of the content on this site are subject to the Usage Terms of the site; third parties using this content agree to abide by any limitations or guidelines and to comply with the Usage Terms of this site. Infineon reserves the right to make corrections, deletions, modifications, enhancements, improvements and other changes to the content and materials, its products, programs and services at any time or to move or discontinue any content, products, programs, or services without notice.