Banner_AURIX_Security-Solution Banner_AURIX_Security-Solution Banner_AURIX_Security-Solution Banner_AURIX_Security-Solution

+ Post New Thread
Page 1 of 34 1 2 3 4 5 11 ... LastLast
Threads 1 to 20 of 663

Forum: Aurix Forum

  1. Sticky Thread Sticky: Quick Training for AURIX™

    Here you can find a Quick Training for AURIX™ (entry-level): ...

    Started by triki‎, Aug 6th, 2019 07:35 AM
    • Replies: 0
    • Views: 527
    Aug 6th, 2019, 07:35 AM Go to last post
  1. TC1766 DMA engine in CAN Boot mode

    Does the DMA engine function in CAN boot mode?

    Started by‎, Sep 16th, 2019 05:44 AM
    • Replies: 3
    • Views: 152
    Yesterday, 07:59 PM Go to last post
  2. AURIX TC234 Wake up

    Hello! I'm trying to implement the using of PINB (P15.1) as a wake up source. I've set: MODULE_SCU.PMSWCR0.B.PINBWKEN = 0b1;...

    Started by mcrt‎, Sep 16th, 2019 10:16 AM
    aurix, aurix.tc23x, gpio, gpio_config, sleep mode, standby mode
    • Replies: 2
    • Views: 130
    Yesterday, 02:59 AM Go to last post
  3. Aurix Motor Control Kit unsharp figure

    Hello, I am currenty working with the Aurix Motor Control Kit and the PDF “eMotor Drive Kit for the AURIX product family”. Unfortunately, Figure...

    Started by JeromeG‎, Sep 18th, 2019 11:41 PM
    • Replies: 0
    • Views: 31
    Sep 18th, 2019, 11:41 PM Go to last post
  4. How many SPI channels can an AURIX TC2xx/ AURIX TC3xx microcontroller have?

    Hi guys, Can you help me with the following question: How many SPI channels can an TC2xx/TC3xx microcontroller have? Thank you and cheers ...

    Started by Lucas‎, Sep 12th, 2019 06:02 AM
    • Replies: 2
    • Views: 123
    Sep 18th, 2019, 11:00 AM Go to last post
  5. TC23x Port configuration

    Hello to all! I have some misunderstanding with the ports configuration. In TC23x datasheet it is shown that port can act as an analog input: ...

    Started by mcrt‎, Sep 18th, 2019 05:43 AM
    • Replies: 1
    • Views: 56
    Sep 18th, 2019, 10:52 AM Go to last post
  6. About asm for TriCore297

    I write asm code with HighTech, I select tricore-gcc as my asm-tool, and I found some problems I found the rule of tricore-gcc for asm is different...

    Started by icework‎, Sep 18th, 2019 03:20 AM
    • Replies: 5
    • Views: 99
    Sep 18th, 2019, 10:52 AM Go to last post
  7. Code on PSRAM and Flash

    I tested my func on PSRAM and Flash to evaluate the difference between psram and flash. I used the default .lsl file, called "Lcf_Gnuc.lsl". For...

    Started by icework‎, Sep 16th, 2019 08:29 AM
    • Replies: 4
    • Views: 191
    Sep 18th, 2019, 03:12 AM Go to last post
  8. TC1766 DMA engine in CAN Boot mode appears to function but detination unchanged

    Conditions: PFLASH0_FSR: bit RPROIN is 1 bit RPRODIS = 0 (meaning read protection is installed and enabled) FLASH_FCON; bit RPA is 1 (meaning...

    Started by‎, Sep 17th, 2019 06:27 AM
    tc1766 can boot dma
    • Replies: 0
    • Views: 91
    Sep 17th, 2019, 06:27 AM Go to last post
  9. Bifaces to Hightec Managed project migration - Aurix TC277

    Hello Everyone, I am trying to setup iLLD demo project into managed Hightec IDE. i am following the document “Bifaces to Hightec Migration” I have...

    Started by deepakseshan1‎, Sep 15th, 2019 11:13 AM
    • Replies: 7
    • Views: 214
    Sep 16th, 2019, 07:57 AM Go to last post
  10. TC1766 DMA engine sample code for software requuested operation

    Looking for example code to set up DMA channel 0 to do a software requested move of 1 byte from PFLASH to SPRAM. Anyone?

    Started by‎, Sep 16th, 2019 05:46 AM
    dma tc1766
    • Replies: 0
    • Views: 40
    Sep 16th, 2019, 05:46 AM Go to last post
  11. Does Entry level Aurix TC2xx and TC3xx come with QFP 64pin package?

    Hi all, Do you know what is the smallest QFP package supported by TC2xx and TC3xx? Is it 64 pin? Thanks for your help! BR Bernie

    Started by Bernie‎, Sep 16th, 2019 12:44 AM
    • Replies: 1
    • Views: 52
    Sep 16th, 2019, 05:11 AM Go to last post
  12. Can VGATE1P be connected to Ground?

    Hello, Can VGATE1P be connected to Ground? Thanks, Bernie #8042000 12585

    Started by Bernie‎, Sep 16th, 2019 12:36 AM
    • Replies: 1
    • Views: 28
    Sep 16th, 2019, 05:08 AM Go to last post
  13. What is the usage of ISTACK, USTACK and CSA?

    Hi all, could you please help me with the following questions: What is the difference of ISTACK, USTACK and CSA? How are they allocated in RAM? ...

    Started by Lucas‎, Sep 16th, 2019 12:32 AM
    • Replies: 1
    • Views: 35
    Sep 16th, 2019, 05:04 AM Go to last post
  14. How to caculate the cycle count?

    Hello, every one. I found some problem after reading the "TriCore DSP Optimization Guide Part 1", in Page169: For Example, the "Example 1" mov.u...

    Started by icework‎, Sep 15th, 2019 03:54 AM
    • Replies: 0
    • Views: 46
    Sep 15th, 2019, 03:54 AM Go to last post
  15. Performance Comparison Between int and float for TC297

    I test the performance difference between int and float through "dotp"(res += a*b). I found the speed of int is slower than float, about half....

    Started by icework‎, Sep 6th, 2019 01:33 AM
    • Replies: 5
    • Views: 392
    Sep 14th, 2019, 04:44 AM Go to last post
  16. How can I get <TriCore DSP Optimization Guide>

    In <TC2xx Core Architecture User Manual (Volume 1)EN>, there are some description as following: The following additional documents are also...

    Started by icework‎, Sep 6th, 2019 05:44 AM
    • Replies: 2
    • Views: 269
    Sep 13th, 2019, 06:50 PM Go to last post
  17. NC Pins connection between TC213 and TC233

    Hi all, Compared between TC213 and TC233, the Pin 48 in TC233 is Vdd and the Pin 48 in TC213 is NC (not connected). I am planning to use...

    Started by Bernie‎, Sep 12th, 2019 05:57 AM
    • Replies: 1
    • Views: 55
    Sep 12th, 2019, 06:43 AM Go to last post
  18. CAN FD support by CAN Bootstrap Loader in Aurix TC2xx/ TC3xx

    Hello, CAN-FD Bootstrap Loader can be supported by AURIX devices? Thank you in advance, BR #8042000 12586

    Started by Bernie‎, Sep 12th, 2019 05:47 AM
    • Replies: 1
    • Views: 59
    Sep 12th, 2019, 06:39 AM Go to last post
  19. Autosar for aurix

    Hi, I want to use Autosar for aurix controller with real time operating system, can any help me to select correct software tool for it.

    Started by KDN‎, Aug 22nd, 2019 08:12 PM
    aurix free tool kit
    • Replies: 1
    • Views: 154
    Sep 12th, 2019, 02:07 AM Go to last post
  20. Flashing device via memtool

    We are using TASKING toolset for development, till now we were flashing TriCore devices (uploading program to device flash memory), using tool...

    Started by bladekp‎, Dec 17th, 2018 09:31 AM
    flash, flash program, memtool, tasking
    • Replies: 6
    • Views: 1,225
    Sep 12th, 2019, 02:01 AM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Tag Cloud


All content and materials on this site are provided “as is“. Infineon makes no warranties or representations with regard to this content and these materials of any kind, whether express or implied, including without limitation, warranties or representations of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, whether express or implied, is granted by Infineon. Use of the information on this site may require a license from a third party, or a license from Infineon.

Infineon accepts no liability for the content and materials on this site being accurate, complete or up- to-date or for the contents of external links. Infineon distances itself expressly from the contents of the linked pages, over the structure of which Infineon has no control.

Content on this site may contain or be subject to specific guidelines or limitations on use. All postings and use of the content on this site are subject to the Usage Terms of the site; third parties using this content agree to abide by any limitations or guidelines and to comply with the Usage Terms of this site. Infineon reserves the right to make corrections, deletions, modifications, enhancements, improvements and other changes to the content and materials, its products, programs and services at any time or to move or discontinue any content, products, programs, or services without notice.