AURIX™ Forum Discussions
Hi,
I want to configure my UART module
TX should happen with 10US that i have configured with GPT ,
RX should happen with Interrupt based.
same when i tested RX got struck in IfxStm_isDeadLine(inline) function.
I want to know why it is getting strucked
Show Less
Can Host read the the PFlash sectors configured as HSM exclusive? Or is it only the debug interface via which we cannot read it.
#HSM #TC3xx #Aurix
Show LessHi,
I have a AURIX MotorControl Application Kit with TC234LF, I want to switch from ADS to Visual Studio Code. I'm going to make it through the GCC compiler, but there is a problem using the winIDEA debugger. WinIDEA requires a license. I did not find a price list on the website and how to buy it.
Are there alternative debuggers that can be used in Visual Studio Code?
Hello
When I do MTU, I found a CAN RAM ECC error report, I can not clear this ecc through clear MTU->MC[MtuIdx].ECCD and FAULTSTS. I think it may clear CAN ECC error first. I want to ask how to clear CAN RAM ECC error? Look foward your response, thank you.
Show Lessstep 1: Lock the debugger interface via 256 bit password, PROCONDBG.OCDSDIS=1 , Confirmation is unlocked state .
step 2: program execution "Disable Protection" command.View theFPRO.PRODISDBG is 1.
Unused HSM!
Problem: After performing the above steps, use miniwiggler still need to enter password for debugging.
- Whether the "Disable Protection" command temporarily enable connect "debug interface " without entering the password?
- Lock the debugger interface via 256 bit password, How to debug without entering a password.
smartconx_target@Q!w2e3r4t5y6u7i8o9p0||/t5/AURIX/TC2xx-debugger-protection/td-p/725591
Show Lesssmartconx_target@Q!w2e3r4t5y6u7i8o9p0||/t5/AURIX/%E7%94%B3%E8%AF%B7ADS%E7%BC%96%E8%AF%91%E5%99%A8/td-p/744522
Show LessDear Team,
may i know if my customer would like to check any system certification for the 800V BMS in factory like ISO21434 and ISO16949 standard?
Regards,
bard
Show LessInfineon确认HSM的随机数生产器是否满足GM/T 0005-2012的要求(随机性检测规范)