Banner_AURIX_Security-Solution Banner_AURIX_Safety_Products ShieldBuddy TC275 Banner_AURIX_OnzerOS Banner_AURIX_DevelopmentStudio

+ Post New Thread
Page 1 of 46 1 2 3 4 5 11 ... LastLast
Threads 1 to 20 of 910

Forum: Aurix Forum

  1. Sticky Thread Sticky: Quick Training for AURIX

    Here you can find a Quick Training for AURIX™ (entry-level): ...

    Started by triki‎, Aug 6th, 2019 08:35 AM
    • Replies: 0
    • Views: 2,494
    Aug 6th, 2019, 08:35 AM Go to last post
  1. How to: Boot interface for tc1775

    Im trying to recover a broken controller, has anyone figured out what pins to jumper in order to put it in boot mode? My first attempt at a tricore...

    Started by 06T200‎, Aug 5th, 2016 05:40 PM
    • Replies: 0
    • Views: 1,889
    Aug 5th, 2016, 05:40 PM Go to last post
  2. Aurix TC29x Trap on flash command

    Hello, we are using the TriBoard for the TC297 B. We are currently using 2 cores (core 0 and core1), running two separate applications there: -...

    Started by 3s_sr‎, May 13th, 2015 08:11 AM
    aurix, dse, pflash trap, store bus error, tc29x, triboard
    • Replies: 2
    • Views: 5,522
    Aug 14th, 2019, 03:16 AM Go to last post
  3. Forum dead/Scanned by Infineon FAEs

    Hi I wonder, do Infineon-FAE check this forum? Is it any good?

    Started by 42BS‎, Jan 5th, 2016 01:29 AM
    • Replies: 0
    • Views: 2,305
    Jan 5th, 2016, 01:29 AM Go to last post
  4. TC29xB: Flash (partly) not visisble

    Hi I am bleeding new to Aurix and have a small problem: I see only 160KB of the internal Flash though there should be 8MB? I check the manual but...

    Started by 42BS‎, Dec 6th, 2015 11:42 PM
    flash, tc29xb
    • Replies: 0
    • Views: 3,724
    Dec 6th, 2015, 11:42 PM Go to last post
  5. Aurix: Atomic access

    Hi the TRM (1.6.x) is not clear about double load/stores: Are these atomic with respect to the second word? Example: ld.d e0,8 Is it...

    Started by 42BS‎, Dec 6th, 2015 11:45 PM
    atomic, tc29x
    • Replies: 0
    • Views: 3,592
    Dec 6th, 2015, 11:45 PM Go to last post
  6. TIM0 or CCU6 on TC23x for PWM acquisition

    I've been reading about both TIM0 (GTM submodule) and CCU6 on the TC23x reference manual, and I would like to ask you wich one should be better for...

    Started by a.montesinos‎, Jul 26th, 2016 01:49 AM
    capture, ccu6, gtm, pwm, tc23x, tim0
    • Replies: 3
    • Views: 4,997
    Aug 25th, 2016, 09:15 AM Go to last post
  7. TIM0 iLLD for TC23x

    Could anyone tell me if there's an iLLD for TIM0 (GTM submodule)? I've download the AURIX iLLD Driver v1., and in the folder...

    Started by a.montesinos‎, Jul 26th, 2016 01:58 AM
    illd, tc23x, tim0, tricore
    • Replies: 0
    • Views: 3,559
    Jul 26th, 2016, 01:58 AM Go to last post
  8. TOM iLLD Standard Driver ERROR

    Hello, I've been recently using the GTM Standard Driver provided by the TC22x iLLD and I've discovered that there's some mistakes in...

    Started by a.montesinos‎, Sep 16th, 2016 01:39 AM
    error, illd, mistake, tom
    • Replies: 0
    • Views: 2,800
    Sep 16th, 2016, 01:39 AM Go to last post
  9. Using the iLLD for TC234 MultiCAN+

    Hello, I'm using the iLLD for TC234 MultiCAN+ and I've found that when you set up the baudrate (using the configuration structure provided by the...

    Started by a.montesinos‎, Nov 8th, 2016 05:03 AM
    aurix, illd, multican+, tc23, tc234, tc23x
    • Replies: 3
    • Views: 3,886
    Nov 27th, 2019, 07:53 AM Go to last post
  10. DMA - RTOS integrating

    Hello, I'm working with Tricore AURIX TC234. I'm trying to integrate an RTOS and everything is working until I add DMA transactions to the code...

    Started by a.montesinos‎, Apr 4th, 2017 01:37 AM
    • Replies: 0
    • Views: 2,062
    Apr 4th, 2017, 01:37 AM Go to last post
  11. AURIX TC23x Standby Mode

    Hello, Im working with the system power modes of the TC234 AURIX microcontroller. Im trying to get the system into Standby mode, following the...

    Started by a.montesinos‎, Nov 3rd, 2017 01:36 AM
    aurix, power management, standby, tc23x, tc324
    • Replies: 1
    • Views: 2,252
    Nov 7th, 2017, 02:50 AM Go to last post
  12. Connect miniWiggler V3 with 22-pin Samtec connector

    I wanto to connect the miniWiggler V3 to a board with a connector as to see in the picture. It is a 22-pin Samtec connector (ERF-8). But I did not...

    Started by a0023‎, May 8th, 2017 07:34 AM
    • Replies: 2
    • Views: 1,827
    May 8th, 2017, 10:33 PM Go to last post
  13. Initializing FLASH driver on target failed

    I always get this message (see title) in Memtool when trying to flash with miniWiggler V3. The message comes together with "Failed to get monitor...

    Started by a0023‎, Jul 14th, 2017 03:19 AM
    • Replies: 1
    • Views: 1,576
    Jul 17th, 2017, 12:17 PM Go to last post
  14. Using MemTool to flash TC297 and TC397

    Hi, We are trying to flash the TC297 and TC397 reference boards with firmware using the memtool. We observed that our hex file has addresses in...

    Started by AAA2020‎, Jan 19th, 2020 03:53 AM
    • Replies: 1
    • Views: 86
    Jan 21st, 2020, 06:30 AM Go to last post
  15. For TriCore Experts | Jump anywhere in the code using 2 bytes

    Hello everybody. I'm trying to statically modify a TriCore ELF file and I need to replace the return instruction to jump to my code. The problem...

    Started by aaah‎, Jul 24th, 2019 07:51 AM
    elf, tricore
    • Replies: 1
    • Views: 571
    Jul 25th, 2019, 07:10 AM Go to last post
  16. TC1793 BGA details (Details about single ball)

    I am searching for the BGA details of TC1793 controller. Who can give support? Regards, Abdul.

    Started by abdulanas‎, Aug 7th, 2012 04:35 AM
    tc1793 bga 416
    • Replies: 1
    • Views: 4,171
    Aug 8th, 2012, 03:14 AM Go to last post
  17. Tricore TC1797 Hard reset

    hi, is it possible to reset a tricore cpu to is factory state , clear all memory including ucb?

    Started by abdulkerim88‎, Nov 12th, 2014 09:06 AM
    • Replies: 0
    • Views: 2,618
    Nov 12th, 2014, 09:06 AM Go to last post
  18. Connecting TC1796 ASC with FT232R, how?

    hi, i am trying to connect a TC1796 in bsl ASC mode to a PC with FT232R chip. until now i didnt succed. can i connect the asc pins directly to...

    Started by abdulkerim88‎, Jan 20th, 2015 10:26 AM
    • Replies: 0
    • Views: 2,332
    Jan 20th, 2015, 10:26 AM Go to last post
  19. Issue connecting TC27x board via miniwiggler

    Hello All, I am trying to connect TC27x device with miniwiggler DAP, but i notice the following error Starting Debugger... The debug...

    Started by abhinand‎, Mar 2nd, 2018 04:19 AM
    dap, miniwiggler, tc27x
    • Replies: 3
    • Views: 1,861
    Mar 13th, 2018, 05:01 AM Go to last post
  20. Input Connections to DSADC of TC277

    Hello All, I am working with DSADC module of TC277. I have a question regarding the input connections to the Modulator for the channel 2....

    Started by abhinand‎, May 23rd, 2018 06:24 AM
    dsadc, tc277
    • Replies: 0
    • Views: 1,152
    May 23rd, 2018, 06:24 AM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Tag Cloud


All content and materials on this site are provided as is. Infineon makes no warranties or representations with regard to this content and these materials of any kind, whether express or implied, including without limitation, warranties or representations of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, whether express or implied, is granted by Infineon. Use of the information on this site may require a license from a third party, or a license from Infineon.

Infineon accepts no liability for the content and materials on this site being accurate, complete or up- to-date or for the contents of external links. Infineon distances itself expressly from the contents of the linked pages, over the structure of which Infineon has no control.

Content on this site may contain or be subject to specific guidelines or limitations on use. All postings and use of the content on this site are subject to the Usage Terms of the site; third parties using this content agree to abide by any limitations or guidelines and to comply with the Usage Terms of this site. Infineon reserves the right to make corrections, deletions, modifications, enhancements, improvements and other changes to the content and materials, its products, programs and services at any time or to move or discontinue any content, products, programs, or services without notice.