Banner_AURIX_Security-Solution Banner_AURIX_Safety_Products ShieldBuddy TC275 Banner_AURIX_OnzerOS Banner_AURIX_DevelopmentStudio


+ Post New Thread
Page 1 of 47 1 2 3 4 5 11 ... LastLast
Threads 1 to 20 of 932

Forum: Aurix Forum

  1. Sticky Thread Sticky: Quick Training for AURIX™

    Here you can find a Quick Training for AURIX™ (entry-level): ...

    Started by triki‎, Aug 6th, 2019 08:35 AM
    • Replies: 0
    • Views: 2,977
    Aug 6th, 2019, 08:35 AM Go to last post
  1. Enabling Semihosting for TriCore App

    Hello, I'm new to MCU programming in general so I apologize if this actually a very basic procedure. I would like to output printf() messages to a...

    Started by pska‎, Dec 13th, 2018 12:17 PM
    debug, semihosting, tricore, ude
    • Replies: 2
    • Views: 1,453
    Feb 14th, 2020, 02:46 PM Go to last post
  2. HW registers that can be written during bootloader and available at Application Run

    Hello Developers I am using Aurix TC27xx and I need to identify connected peripheral with a HW instance ID during bootloader mode . I am planning...

    Started by Abhi_run‎, Feb 14th, 2020 07:55 AM
    adc, bootloader, bootmode header, can driver, eeprom, memory access, memory protection, memory settings, register, reset
    • Replies: 0
    • Views: 59
    Feb 14th, 2020, 07:55 AM Go to last post
  3. Cache invalidation

    Hi all, I'm working on AURIX TC277TU architecture and I'm not able to find how to invalidate CPUs data caches. TC277TU has two different...

    Started by Italo‎, Jan 22nd, 2015 07:23 AM
    • Replies: 6
    • Views: 4,700
    Feb 13th, 2020, 12:25 PM Go to last post
  4. TC233 , Memtool and UART

    Trying to program TC233 via ft232rl usb serial using memtool and have no luck to do that , no communication , mcu responds to custom bootloader ,...

    Started by Saulyss‎, Feb 7th, 2020 12:48 PM
    • Replies: 2
    • Views: 183
    Feb 13th, 2020, 08:21 AM Go to last post
  5. Measurement individual core usage on TC39xx

    Hello all, I am wondering that is there any way to measure/capture individual core usage on uC TC39xx. One approach I found is calculate the...

    Started by Cuongtv4‎, Feb 12th, 2020 08:56 PM
    • Replies: 1
    • Views: 62
    Feb 13th, 2020, 05:03 AM Go to last post
  6. HSSL/HSCT channel usage

    Hi, I am implementing a aurix-fpga communication with the HSSL/HSCT link and after reading the documentation I would need a bit of clarification on...

    Started by jhonka‎, Feb 12th, 2020 09:48 AM
    • Replies: 0
    • Views: 76
    Feb 12th, 2020, 09:48 AM Go to last post
  7. EXternal clock not working - EXTCON0

    Hello, I am trying to use the external clock where I configure the register and relavant pin according to the requirement but the clock is not...

    Started by deepakseshan1‎, Feb 7th, 2020 08:38 AM
    • Replies: 6
    • Views: 324
    Feb 11th, 2020, 04:44 PM Go to last post
  8. Proper way to modify SCU_CCUCON0.BAUD2DIV

    I'm trying to change the SCU clock divider for the QSPI module to get a higher SPI clock rate. I tried to change it the straightforward way, e.g. ...

    Started by TMorita‎, Jan 16th, 2020 08:20 PM
    • Replies: 4
    • Views: 263
    Feb 11th, 2020, 06:27 AM Go to last post
  9. TC3xx has SOTA feature How it works

    How SOTA feature is operated and swapping of PFLASH Banks takes place

    Started by sanjay696‎, Oct 29th, 2019 05:23 AM
    tc 3xx
    • Replies: 5
    • Views: 604
    Feb 11th, 2020, 01:09 AM Go to last post
  10. SAK-TC397 BGA-292 Aurix 2G Triboard TLF355384 5V/3.3V detection in software

    Hello Support, In the Aurix 2G SAK-TC397 BGA-292 Triboard Hardware Version 2.01, there are two possible population of TLS35584 device. ...

    Started by baexps_pr1‎, Feb 8th, 2020 04:27 AM
    • Replies: 1
    • Views: 182
    Feb 10th, 2020, 08:29 AM Go to last post
  11. PMS_AG21_STDBY=0 or 1 for SAK-TC387TP when all external power supplies are used

    Hello Support, In a Pristine SAK-TC387TP device from Infineon without any Flash Image content being present within the device, is it guaranteed...

    Started by baexps_pr1‎, Jan 31st, 2020 11:48 AM
    • Replies: 3
    • Views: 286
    Feb 10th, 2020, 08:27 AM Go to last post
  12. CAN FD configuration for TC264D

    Hi, we have working standard CAN for 500 Kbps, now we are developing CAN FD on top it for Micro Controller (SAL TC264 D). These are the...

    Started by Dinesh Reddy‎, Feb 10th, 2020 05:49 AM
    canfd, infineon, tasking, tc264, tricore
    • Replies: 0
    • Views: 97
    Feb 10th, 2020, 05:49 AM Go to last post
  13. How to recover SPD and BRD error in QSPI module

    Hi all, How to recover SPD and BRD error in QSPI module ? Best regards, Lina #8042000 13101

    Started by Lina‎, Feb 4th, 2020 03:20 AM
    • Replies: 1
    • Views: 178
    Feb 6th, 2020, 04:29 AM Go to last post
  14. TC275 DMA Configuration

    Hello All, I am facing a problem in configuring the DMA Controller i.e. configuring the Move Engine(MEx) of an active DMA channel for two...

    Started by NeerajSDI‎, Feb 3rd, 2020 03:28 AM
    dma, dma interrupt, double destination buffer, uart
    • Replies: 5
    • Views: 350
    Feb 5th, 2020, 01:43 PM Go to last post
  15. GETH - Dynamic per Packet Routing

    (Board: TriBoard TC3x7 TH V2.01) Hi, referencing the 3xx Manual 44.3.9.5.2, it should be possible to route a packet based on the destination...

    Started by marbri‎, Feb 3rd, 2020 02:28 AM
    dma, geth, mapping, queue
    • Replies: 0
    • Views: 133
    Feb 3rd, 2020, 02:28 AM Go to last post
  16. Bifaces Project - Multiple .elf setup - conditional compile

    Hi, i created a project with the Bifaces multiple .elf example, which works fine. Based on that, i would like to use the same source files for...

    Started by marbri‎, Feb 3rd, 2020 12:38 AM
    bifaces, compile, conditional
    • Replies: 0
    • Views: 105
    Feb 3rd, 2020, 12:38 AM Go to last post
  17. Tricore context to save/restore to implement threading

    For my application, I need to run multiple pieces of code that are single-threaded. The solution I'm planning to use is to implement a cooperative...

    Started by TMorita‎, Jan 31st, 2020 04:44 PM
    • Replies: 5
    • Views: 253
    Feb 2nd, 2020, 07:37 PM Go to last post
  18. TC234 QSPI non-DMA problem

    I'm writing an SD card driver using the SPI interface. As part of the initialization sequence, I need to send 10 0xff bytes to the SD card. I call...

    Started by TMorita‎, Dec 26th, 2019 01:29 PM
    2 Pages
    1 2
    • Replies: 11
    • Views: 1,300
    Feb 2nd, 2020, 04:28 PM Go to last post
  19. Safety Flip-Flop feature description needed

    Hello Support, In the Aurix 2G User Manual, I am looking for a chapter which explains the meaning of Safety Flip-Flop feature from the end-user...

    Started by baexps_pr1‎, Jan 30th, 2020 03:10 PM
    • Replies: 1
    • Views: 150
    Jan 31st, 2020, 05:43 AM Go to last post
  20. TC36x CPU memories interconnexion

    Hello, In case of TC36x we would like to confirm that CPU0 can access to CPU1 memories and CPU1 can access to CPU0 memories through SRI interconnect...

    Started by floggy22‎, Jan 31st, 2020 03:59 AM
    • Replies: 1
    • Views: 123
    Jan 31st, 2020, 05:15 AM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Tag Cloud

Disclaimer

All content and materials on this site are provided “as is“. Infineon makes no warranties or representations with regard to this content and these materials of any kind, whether express or implied, including without limitation, warranties or representations of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, whether express or implied, is granted by Infineon. Use of the information on this site may require a license from a third party, or a license from Infineon.


Infineon accepts no liability for the content and materials on this site being accurate, complete or up- to-date or for the contents of external links. Infineon distances itself expressly from the contents of the linked pages, over the structure of which Infineon has no control.


Content on this site may contain or be subject to specific guidelines or limitations on use. All postings and use of the content on this site are subject to the Usage Terms of the site; third parties using this content agree to abide by any limitations or guidelines and to comply with the Usage Terms of this site. Infineon reserves the right to make corrections, deletions, modifications, enhancements, improvements and other changes to the content and materials, its products, programs and services at any time or to move or discontinue any content, products, programs, or services without notice.