AURIX™ Forum Discussions

Hi,

after flashing (iROM) the LCDDemo provided by the Free Aurix Entry Toolchain, the TC2X7 V1.0 Application Kit Board is performing an reset within an second after every startup of the application. Therefore i can't flash the board by the Toolchain anymore, because no connection can be estabiled or the board is disconnected after the board resets.

Is there any possiblity to halt the board after the startup and stop the execution of the the application code e.g. by an hardware pin, so that i can erase the application code or flash a new one?

I'm thankful for every hint, which could lead to an solution of my problem!

Best regards
Lukas Show Less

Hi,

starting from the examples MCMCAN_1_KIT_TC375_LK and ADC_Single_Channel_1_TC375_LK I have to send the value acquired from the analog channel with a CAN message. This is how I've tried to do that:

Show Less

We are using Tasking IDE on Aurix evaluation board. There’s a build in miniWiggler debugger. We can use this miniWiggler debugger to debug the code. We can set break points, stop at break points, evaluate variables at break points. However, one main feature is not working in all the PCs: we cannot do “step into”, “single step”, “step through” features. We must unset the break point in the current step and set a break point in the next step then hit “continue to run” to mimic the “single step” feature. Is that the problem with the debugger? Do j-link debugger work with Tasking IDE?

Thank you so much for your answer.

Show Less

Hi,

I have a AURIX MotorControl Application Kit with TC234LF, I want to switch from ADS to Visual Studio Code. I'm going to make it through the GCC compiler, but there is a problem using the winIDEA debugger. WinIDEA requires a license. I did not find a price list on the website and how to buy it. 

Are there alternative debuggers that can be used in Visual Studio Code?

Show Less

Hello,

I am facing an issue while writing data to the DFlash memory region. I am using the TC375 Flash programming Example code with some changes. Below is the scenario for which I am facing the issue.

1. The first time writing data (0xAF000400) to the address 0xAF000240 is writing successfully.

2. reading data from 0xAF000240 reading successfully.

3. If I write the data that is read from 0xAF000240 to the same address by updating the data with some other value, the memory(0xAF000240) is filling with zeros (0x00000000).

Can any one please suggest the solution. 

Thank you very much !

 

 

 

 

Show Less

请教大家一个问题

我现在做的boot程序在跳转app程序的时候，如果boot程序和app程序都没有使用中断的情况下可以正常跳转，但是boot程序或app程序有一方面使用中断的话就会进入到debug，boot程序或app程序单独运行时没有问题。下面按照串口中断举例。

调试状态下会卡在下图位置：

我想知道是哪个地方设置的不对或者少设置了什么地方。

Show Less