AURIX™ Forum Discussions

Hello Infineon Team,

I am using TC377_ED_EX AURIX Tricore microcontroller, I have integrated RTOS code with my general configurations, code was built successfully in Tricore IDE, however after flashing code in Lauterbach T32 debugger, and doing step over at every function and getting trap at __mtcr().

If code is in trap, then in some trap registers it should show status in trap registers, but in Trap registers also there is no specific value only 0000000 given.

for better understanding, I am attaching screenshots of call stack, error window, & registers value log

Hope you will provide me better solution to overcome this issue.

Thanks,

Poonam

I am learning the GTM DPLL sub-module. How can I know whether it is GTM-IP or GTM-RM according to the GTM_REV register of TC275?

Hi, I am using Aurix TC375 Lite Kit development board and tried the freeRtos example code.

But after compilation, once the code is put in the debugger mode then the tsim issue comes as below snapshot --

Please get me a solution for this issue asap.

Thanks.

Hi, I can't add any printf or can't use UART from sample Ethernet application

if I add anything there it is crashing

I need to process data after receiving from Ethernet but if I try to do anything application just crash. So how and where to process Ethernet data. 

Newbe here ( i have asked questions about other items i'm working on , CAN mainly ) i'm running through the examples with regards PWM generation and reading Analogue voltages.

I'm involved in a project where i will need to run a number of vales at 20khz but read the current coming back from the  current sense circuit connected to them , in the end P.I. control over the current in the valve.  I'm unsure which way to go .  

I've tried looking at examples for CCU60 and then adapting the ADC examples in to it  but nothing comes back off the ADC or i receive a trap error in debug  - can i run ccu60 and get it to trigger ADC .

i've added 

Hello,

I am working on TC397 processor. I am investigating the Safety Protection System for my application and in this regard I came across DAM being a Bus Master with Tag IDs. 

Can I know what's the use of DAM being a Bus Master? I am confused as to a memory being a Bus master..

PS: I am new to the Aurix series of processors and consider me a beginner.

Thanks.

Background Info: 

This answer seems to have some content, but couldn't understand much from that

https://community.infineon.com/t5/AURIX/Master-TAG-ID-Table-in-Aurix-2G-doesn-t-have-LMU-Module-entry/td-p/316781

@MoD