AURIX™ Forum Discussions
Using Aurix Development studio, I have implemented standalone project for TC389 EVAL Board EDSADC with Single Ended channel configuration, selected channel is AN20CH2, with decimation factor 32, Full scale - 65535 for unsigned mode. Filters and integrator disable.
Giving input externally through function generator as below parameters:
Frequency: 100Hz, Amplitude: 1.5Vpp Offset: 2.5V
Observing positive half cycle little bit clamped for above function generator setting and amplitude more than 1Vpp, what can be issue? is it in configuration?
Show Less
Hello,
How can I modify the MultiCAN example code for Aurix TC265 to enable transmission of CAN messages over a CAN channel using "Normal Mode" instead of "LoopBack" mode?
Currently on the Aurix website I can not find single example explaining this. Please provide an example that can help me develop the CAN driver.
Kind regards,
Yashaswi Dhiman
Hi.
I'm a student. I have a PCB with the SAK-TC214L-8F133 chip on it. I would like to be able to connect to it using Memtool. I see Memtool supports this layout. I have a USB-UART converter.
How should I connect from the hardware side? Connect TxD from the converter to P14.1 (ASCLIN0_RXA) and RxD to P14.0 (ASCLIN0_TX)? I did that, but Memtool does not detect the chip. Do I need to short any configuration pins to VCC/GND?
I will be grateful for your help.
I've configured Icu module on DaVinci to detect PWM input signal frequency change and raise an interrupt for CPU intervention when the frequency changes from low to high.
However, I receive this error shown below:
ltc E106: unresolved external: Icu_17_TimerIp_Config - (EcuM_Callout_Stubs.o)
What would be the root cause?
Best,
B.
Show Lesssmartconx_target@Q!w2e3r4t5y6u7i8o9p0||/t5/AURIX/TC-397-HSM-%E7%94%A8%E6%88%B7%E5%BC%80%E5%8F%91%E6%8C%87%E5%8D%97/td-p/716773
Show LessI need to Transmit and Receive CAN Msg. I cannot initialize external CAN Bus. How to initialize external CAN Pins in EVAL kit TC234 and Transmit/ Receive CAN Messages. I am Sharing my code below.
Show LessI just bought a MiniWiggler v2 but having some challenges of establishing connection with TC277. After we power up the device and connect all the DAP lines to PC through MiniWiggler, the DAS basic client shows that the status of the connection is continuously switching between “no device connected”, “Device has no ID register” and “TriCore Family” in an infinite loop.
I am using the 10 pin dap connector on the miniwiggler and the wiring is showed in the picture below:
Another thing I notice is when I connect the miniwiggler to the computer, it will list under USB section in device manager instead of COM port. Is this the reason of no connection? And I did update the drivers already.
Please let me know what could be the reason of this issue and how can I have a stable connection. Show Less
Hello,
I am trying to connect Infineon Miniwiggler v3 to the Aurix Tc387, by using Infineon Memtool 2021.8.
But couldn't able to establish the connection between them.
Need support related to Memtool Settings and need details for DAP Miniwiggler v3.
Please support!!
Show Less