PDA

View Full Version : How to connect and use External RAM??



Manu_00
May 2nd, 2013, 11:59 PM
Hey,

Could someone give me an advice how to connect external RAM to the External Bus Interface of the controller . What things have to be considered when using an external RAM. And how do i have to set up my project te get access to the external RAM or enable it?

regards

Travis
May 9th, 2013, 03:03 AM
Hi, in general you have to take note of the EBU interface signals such as the Address/Data line, CS, CLK etc. Next you have to understand the datasheet of your selected device so that you can do the necessary configuration on the EBU. I cannot be specific here until you have a selected device.

Manu_00
May 15th, 2013, 06:35 AM
Thanks for the information. But do i have to do any special settings in my project to enable the external RAM and to use it?