PDA

View Full Version : Bsl



frankmag
Nov 7th, 2013, 11:05 AM
Hi,
Is there any trick to enter BSL mode without pulling down TMS at startup? Maybe enabling some sort of pull down on TMS at runtime then restarting the micro?
Or viceversa, is it possible to enter BSL mode and then leave it after some time?
I would like to be able to use only the serial line to flash the micro without using dip switches ... .

Many thanks
Frank

Travis
Nov 10th, 2013, 06:55 PM
Hi,
Is there any trick to enter BSL mode without pulling down TMS at startup? Maybe enabling some sort of pull down on TMS at runtime then restarting the micro?
Or viceversa, is it possible to enter BSL mode and then leave it after some time?
I would like to be able to use only the serial line to flash the micro without using dip switches ... .

Many thanks
Frank

Sorry to say that this is not possible. The TCK and TMS levels need to be set according to the tables for respective Boot modes. However you might want to review the possibilities of BMI for your application.

429