Not applicable
Oct 09, 2015
04:36 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 09, 2015
04:36 AM
Hi I am using XMC4100 and I am struct in running CCU4 timer. Whenever I am trying to set TRBS bit of particular TCSET register it's not getting set. I wanted to know if there is any prerequisite for setting TRBS bit ? I mean do i need to enable some other features before setting this bit (I have configured other registers as per Initialization sequence given in the reference manual )? Waiting for the response.
Labels
- Tags:
- IFX
2 Replies
Oct 12, 2015
08:19 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 12, 2015
08:19 PM
Hello,
I don't think there are any pre-requisites to set TCSET register. Of course, it makes sense to start the timer only after all configurations have been done.
As I mentioned in the other thread, the timer run bit TRBS in TCSET register is a write-only register. Read is always 0 so this is not a problem.
Regards,
Min Wei
I don't think there are any pre-requisites to set TCSET register. Of course, it makes sense to start the timer only after all configurations have been done.
As I mentioned in the other thread, the timer run bit TRBS in TCSET register is a write-only register. Read is always 0 so this is not a problem.
Regards,
Min Wei
Not applicable
Oct 13, 2015
05:24 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 13, 2015
05:24 AM
yea the issue has been solved. Thanks for your response 🙂