Not applicable
Mar 05, 2015
12:03 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 05, 2015
12:03 AM
Good morning,
I have an XE166/XE2000 application with a well tested CAN bus library. I would like to port it to XMC 4500, but I didn't found any application note or information on Infineon web site.
I need Fifo/Gateway mode, so the CAN001/CAN002 Dave app is not OK.
Regards
Christophe
I have an XE166/XE2000 application with a well tested CAN bus library. I would like to port it to XMC 4500, but I didn't found any application note or information on Infineon web site.
I need Fifo/Gateway mode, so the CAN001/CAN002 Dave app is not OK.
Regards
Christophe
2 Replies
Not applicable
Mar 06, 2015
05:13 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 06, 2015
05:13 AM
if you had used a c-library in the past, you might better to look at the XMC lib now.
Attachments are accessible only for community members.
Mar 10, 2015
03:05 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 10, 2015
03:05 AM
christopheroj wrote:
Good morning,
I have an XE166/XE2000 application with a well tested CAN bus library. I would like to port it to XMC 4500, but I didn't found any application note or information on Infineon web site.
I need Fifo/Gateway mode, so the CAN001/CAN002 Dave app is not OK.
Regards
Christophe
You can make use of DAVE2 with selected device of TC1793 and work on the CAN module which has the same CAN module as XMC4500. With the code generated from DAVE2 you can then port this to your XMC4500 software. This is an unofficial solution but it's workable (see attachment).