Not applicable
May 01, 2014
06:17 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 01, 2014
06:17 AM
Hello ,
is there a possibility to get "direct Access" to the signals TxD and RxD (UART)?
At the moment, all I have is a virtual COM Port via USB.
I need this Serial Interface for "programming" a touch Display,...
Thanks
Winfried
is there a possibility to get "direct Access" to the signals TxD and RxD (UART)?
At the moment, all I have is a virtual COM Port via USB.
I need this Serial Interface for "programming" a touch Display,...
Thanks
Winfried
- Tags:
- IFX
2 Replies
Not applicable
May 07, 2014
01:33 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 07, 2014
01:33 AM
Hi Winfried,
The pin connected to the Virtual COM port is P2.1 and P2.2 but these two pins does not have the pin out.
However, if you need to signal out data, you can always setup your UART for other pins which have the pin out available.
The pin connected to the Virtual COM port is P2.1 and P2.2 but these two pins does not have the pin out.
However, if you need to signal out data, you can always setup your UART for other pins which have the pin out available.
Not applicable
May 24, 2014
12:24 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 24, 2014
12:24 PM
Hi Jackson,
thanks for your answer, the last weeks I didn´t have to much time to "play" with the XMC2GO,...
But this afternoon - I "reconnectet" TxD to P0_14, it works,...
Bye and thanks
Winfried
thanks for your answer, the last weeks I didn´t have to much time to "play" with the XMC2GO,...
But this afternoon - I "reconnectet" TxD to P0_14, it works,...
Bye and thanks
Winfried