Not applicable
Apr 11, 2014
08:06 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 11, 2014
08:06 AM
Hi Fellow Forum Members,
I have been trying to program an XMC4400 on the hexagon dev kit using Rowley CrossStudio 2.3. The code that I have works fine on the debugger but not when I try to run from a hard reset. I have ensured that the STARTUP_FROM_RESET define is present which should allow the application to boot.
Has anyone else had any problems with this and is there a known solution? Am I missing something obvious?
Thanks
Jon
I have been trying to program an XMC4400 on the hexagon dev kit using Rowley CrossStudio 2.3. The code that I have works fine on the debugger but not when I try to run from a hard reset. I have ensured that the STARTUP_FROM_RESET define is present which should allow the application to boot.
Has anyone else had any problems with this and is there a known solution? Am I missing something obvious?
Thanks
Jon
0 Replies