Not applicable
Feb 19, 2014
01:51 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 19, 2014
01:51 AM
Hello,
i got a XMC4500_45A_V3 General Purpose Kit with the COM Exp. Board.
I would like to Flash it with the ASC Bootloader terminal Programm, but the COM Board only has a RS485 and a CAN Interface.
My PC only has RS232.
It is possible to connect it to my PC anyway or do i need an apdater 485->232?
Thanks a lot!
i got a XMC4500_45A_V3 General Purpose Kit with the COM Exp. Board.
I would like to Flash it with the ASC Bootloader terminal Programm, but the COM Board only has a RS485 and a CAN Interface.
My PC only has RS232.
It is possible to connect it to my PC anyway or do i need an apdater 485->232?
Thanks a lot!
- Tags:
- IFX
1 Reply
Not applicable
Feb 25, 2014
10:17 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 25, 2014
10:17 PM
Hi Hissi,
The connector pin out is different from RS485 and RS232.
So I don't think you can use directly with RS232.
Does your PC have USB port? Since you using V3 board, the board provide virtual COM port.
You can use it to connect the board with your terminal program.
rgds,
Rou
The connector pin out is different from RS485 and RS232.
So I don't think you can use directly with RS232.
Does your PC have USB port? Since you using V3 board, the board provide virtual COM port.
You can use it to connect the board with your terminal program.
rgds,
Rou